曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

P/N 11934-S43 7 of 14
Cirrus Design Section 9
SR20 Supplements
Landing Without Elevator Control
The pitch trim spring cartridge is attached directly to the elevator and
provides a backup should you lose the primary elevator control
system. Set elevator trim for a 80 KIAS approach to landing.
Thereafter, do not change the trim setting until in the landing flare.
During the flare, the nose-down moment resulting from a power
reduction may cause the airplane to hit on the nosewheel. At
touchdown, bring the power lever to idle.
1. Control Yoke................................................... ATTEMPT TO FREE
Clasp both hands around the control yoke and pull straight back
and forth in a strong, steady, and continuous motion.
2. If no elevator control, attempt to use Trim System to control aircraft
pitch:
a. If Trim System inoperative or has no affect on aircraft pitch:
(1) Perform Forced Landing Checklist.
b. If Trim System affects aircraft pitch:
(1) Flaps ...................................................................SET 50%
(2) Trim...............................................................SET 80 KIAS
(3) Power .......................AS REQUIRED FOR GLIDE ANGLE
Original Issue: 01-20-09
8 of 14 P/N 11934-S43
Section 9 Cirrus Design
Supplements SR20
Power Lever Linkage Failure
If the Power Lever linkage fails in flight, the engine will not respond to
power lever control movements. Use power available and flaps as
required to safely land the airplane.
If the power lever is stuck at or near the full power position, proceed to
a suitable airfield. Fly a forced landing pattern. With landing assured,
shut down engine by moving mixture control full aft to CUTOFF. If
power is needed again, return mixture control to full RICH and regain
safe pattern parameters or go-around. If airspeed cannot be
controlled, shut engine down and perform the Forced Landing
checklist. After landing, bring the airplane to a stop and complete the
Emergency Engine Shutdown on Ground checklist.
If the power lever is stuck at or near the idle position and straight and
level flight cannot be maintained, establish glide and perform the
Forced Landing checklist.
1. Power Lever Movement......................................................VERIFY
2. Power ............................................................................ SET if able
3. Flaps ........................................................................SET if needed
4. Mixture ..................................... AS REQUIRED (full rich to cut-off)
5. Land as soon as possible.
Original Issue: 01-20-09
P/N 11934-S43 9 of 14
Cirrus Design Section 9
SR20 Supplements
Section 3A - Abnormal Procedures
Inadvertent Icing Encounter
Flight into known icing conditions is prohibited. However, if icing is
inadvertently encountered:
1. Pitot Heat ...................................................................................ON
2. Exit icing conditions. Turn back or change altitude.
3. Cabin Heat .....................................................................MAXIMUM
4. Windshield Defrost...................................................... FULL OPEN
5. Alternate Induction Air ...............................................................ON
6. Landing Configuration................................................. FLAPS 50%
7. Airspeed........................................................................85-90 KIAS
Landing without Aileron Control
1. Control Yoke................................................... ATTEMPT TO FREE
Clasp both hands around the control yoke and twist right and left
in a strong, steady, and continuous motion.
2. If no aileron control:
a. Maintain roll control using smooth rudder pedal inputs.
b. Maximum Bank Angle ..........................DO NOT EXCEED 20°
c. Maximum Landing Crosswind .................................10 KNOTS
d. Landing Configuration .......................................... FLAPS 50%
e. Airspeed .................................................................85-90 KIAS
Original Issue: 01-20-09
10 of 14 P/N 11934-S43
Section 9 Cirrus Design
Supplements SR20
Landing without Rudder Control
1. Rudder Pedals ...............................................ATTEMPT TO FREE
Place feet on rudder pedals and push right and left pedals in a
strong, steady, and continuous motion.
2. If no rudder control:
a. Maintain directional control using smooth aileron inputs.
b. Maximum Bank Angle...........................DO NOT EXCEED 20°
c. Maximum Landing Crosswind..................................10 KNOTS
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：Cirrus Design SR20西銳20飛行員操作手冊和飛機飛行手冊附錄(50)