曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

Revision 2: 08-15-07
P/N 13772-103 9 of 10
Cirrus Design Section 9
SR22 Supplements
Jeppesen NavData card slot in each panel. The GNS 430 navigator is
powered by 28 VDC through the 5-amp GPS1 circuit breaker on the
Avionics Essential Bus.
The Jeppesen Navigation Database provides access to data on
Airports, Approaches, Standard Instrument Departures (SIDs),
Standard Terminal Arrivals (STARs), VORs, NDBs, Intersections,
Minimum Safe Altitudes, Controlled Airspace Advisories and
Frequencies. North American and International databases are
available. Database information is provided on a card that can be
inserted into the card slot on the GPS unit. Subscription information is
provided in a subscription packet provided with each system.
Navigation (Nav) Receiver
The Garmin GNS 430 provides an integrated Navigation (NAV)
receiver with VHF Omnirange/Localizer (VOR/LOC) and Glideslope
(G/S) capability. The VOR/LOC receiver receives on a frequency
range from 108.000 Mhz to 117.950 Mhz with 50 kHz spacing.
Glideslope is received from 329.150 to 335.00 in 150 kHz steps. The
Nav receiver controls are integrated into the Garmin GNS 430 control
mounted in the center console. The receiver control provides active
and standby frequency indication, frequency memory storage, and
knob-operated frequency selection. IDENT audio output for VOR and
LOC is provided to the audio system. The Nav antenna is mounted on
top of the vertical tail. 28 VDC for navigation receiver operation is
controlled through the Avionics Master Switch on the bolster switch
panel and supplied through the 5-amp GPS 1 circuit breaker on the
Avionics Essential Bus. The airplane is equipped with a Garmin GNS
430 integrated GPS Navigator, Navigation (NAV) receiver with VHF
Omnirange/Localizer (VOR/LOC) and Glideslope receiver.
Communication (COM) Transceiver
The GNS 430 includes a digitally-tuned integrated VHF
communications (COM) transceiver. The transceiver and integrated
controls are mounted in the Garmin GNS 430 unit. The transceiver
receives all narrow- and wide-band VHF communication transmissions
transmitted within a frequency range of 118.000 MHz to 136.975 MHz
in 25.0 kHz steps (720 channels). For European operations, the COM
can be operator configured for 8.33 kHz channel spacing (2280
channels). The tuning controls are collocated with the NAV at the left
Revision 2: 08-15-07
10 of 10 P/N 13772-103
Section 9 Cirrus Design
Supplements SR22
side of the GNS 430 front panel. Frequency tuning is accomplished by
rotating the large and small concentric knobs to select a standby
frequency and then transferring the frequency to the active window.
The COM frequency display window is at the upper left corner of the
GNS 430 display. Auto-tuning can be accomplished by entering a
frequency from a menu. The COM 1 antenna is located above the
cabin on the airplane centerline. 28 VDC for transceiver operating is
controlled through the Avionics Master Switch and supplied through
the 7.5-amp COM1 circuit breaker on the Avionics Essential Bus.
TERRAIN Interface*
• Note •
*TERRAIN functionality is a standard feature found in GNS
430 units with main software version 5.01 or above and valid
terrain and obstacle databases installed.
Garmin TERRAIN is a terrain awareness system incorporated into
GNS 430 units to increase situational awareness and aid in reducing
controlled flight into terrain. The TERRAIN function displays altitudes
of terrain and obstructions relative to the aircraft’s altitude and are
advisory in nature only. Individual obstructions may be shown if
available in the database, however, not all obstructions may be
available in the database and data may be inaccurate. TERRAIN
information should be used as an aid to visual acquisition and not use
to navigate or maneuver to avoid terrain.
For for a more detailed description of the TERRAIN function, refer to
the Garmin GNS 430 Pilot's Guide and Reference, P/N 190-00140-00,
Revision H dated May 2006 or later revision.
Revision 2: 08-15-07
P/N 13772-104 1 of 8
Cirrus Design Section 9
SR22 Supplements
Pilot’s Operating Handbook and
FAA Approved Airplane Flight Manual
Supplement
For
Garmin GNC 420 GPS Navigator
When a GARMIN GNC 420 GPS Navigator with VHF COM is installed
in the Cirrus Design SR22, this Supplement is applicable and must be
inserted in the Supplements Section (Section 9) of the Cirrus Design
SR22 Pilot’s Operating Handbook. This document must be carried in
the airplane at all times. Information in this supplement either adds to,
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：Cirrus Design SR20西銳20飛行員操作手冊和飛機飛行手冊附錄(57)