曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

The crew should be aware that altitude constraints in the MCDU F-PLN page are observed only when the climb is managed, i.e. when CLB is displayed on the FMA. Any other vertical mode will disregard any altitude constraints.
A likely scenario would be, when the FCU altitude is set above an altitude constraint and the pilot selects V/S when below that constraint to avoid a potential TCAS TA. In this case, the aircraft will disregard the altitude constraint.
 

  NORMAL OPERATIONS
CLIMB
A318/A319/A320/A321
FLIGHT CREW TRAINING MANUAL 

SPEED CONSIDERATIONS
Applicable to: ALL
The climb speed may be either:
? Managed
? Selected
MANAGED
The managed climb speed, computed by the FMGS, provides the most economical climb profile as it takes into account weight, actual and predicted winds, ISA deviation and Cost Index (CI). The managed climb speed also takes into account any speed constraints, e.g. the default speed limit which is 250 kt up to 10 000 ft.
SELECTED
If necessary, the climb speed can be either pre-selected on ground prior to take-off on the MCDU PERF CLIMB page or selected on the FCU as required.
On ground, prior take-off, speed target at acceleration altitude can be pre-selected on the MCDU PERF CLIMB page. It is to be used when the F-PLN has a sharp turn after take-off, when high angle of climb is required or for ATC clearance compliance.
Once airborne, the speed can be selected on FCU to achieve the maximum rate of climb or the maximum gradient of climb.
The speed to achieve the maximum rate of climb, i.e. to reach a given altitude in the shortest time, lies between ECON climb speed and green dot. As there is no indication of this speed on the PFD, a good rule of thumb is to use turbulence speed to achieve maximum rate.
The speed to achieve the maximum gradient of climb, i.e. to reach a given altitude in a shortest distance, is green dot. The MCDU PERF CLB page displays the time and distance required to
achieve the selected altitude by climbing at green dot speed. Avoid reducing to green dot at high altitude, particularly at heavy weight, as it can take a long time to accelerate to ECON mach. Pilots should be aware that it is possible to select and fly a speed below green dot but there would be no operational benefit in doing this.
When selected speed is used, the predictions on the F-PLN page assume the selected speed
is kept till the next planned speed modification, e.g. 250 kt /10 000 ft, where managed speed is supposed to be resumed. Consequently, the FM predictions remain meaningful.
When IAS is selected in lower altitude, there is an automatic change to Mach at a specific crossover altitude.
Finally, as selected speed does not provide the optimum climb profile, it should only be used when operationally required, e.g. ATC constraint or weather.
 

  NORMAL OPERATIONS
CLIMB
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A318/A319/A320/A321 機組訓練手冊 FCTM Flight Crew Training Manual(72)