曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

For affected ADR (s) identification, the flight crew may, either level off and stabilize the flight using the dedicated table in PART 2, or, if for instance already stabilized in climb, use the CLIMB table given in part 3. The trouble shooting will be more accurate, using the level off table.
LEVEL OFF AND STABILIZATION (IF REQUIRED)
The table gives the proper pitch and thrust values for stabilization in level off according to weight, configuration and altitude.
It must be noticed that, if the altitude information is unreliable, FPV and V/S are also affected.
In this case, the GPS altitude, if available, is the only means to confirm when the aircraft is maintaining a level. When reliable, the FPV should be used.
If the memory items have been maintained for a significant period of time, the current speed may be quite above the target.
�� If FPV is reliable, or if GPS altitude information is available:
‐ Maintain level flight (FPV on the horizon or constant GPS altitude)
‐ Adjust thrust according to the table
‐ Observe the resulting pitch attitude, and compare it with the recommended table pitch target.
? If the aircraft pitch to maintain level flight is above the table pitch target, the aircraft is slow, then increase thrust
? If the aircraft pitch to maintain level flight is below the table pitch target, the aircraft is fast, then decrease thrust
When the pitch required to maintain level off gets close to the table pitch target, re-adjust thrust according to table thrust target.
This technique permits to stabilize the speed quickly, without inducing altitude changes.
 

  ABNORMAL OPERATIONS
NAVIGATION
A318/A319/A320/A321
FLIGHT CREW TRAINING MANUAL 

�� If FPV is not reliable and GPS altitude information is not available (no means to ensure level flight):
Adjust pitch and thrust according to table, and wait for speed stabilization. Expect a significant stabilization time and important altitude variations.
TROUBLE SHOOTING AND FAULT ISOLATION
When one indication differs from the others, flight crews may be tempted to reject the outlier information. They should be aware, however, that in very extreme circumstances, it may happen that two, or even all three ADRs may provide identical and erroneous data.
BEWARE OF INSTINCTIVELY REJECTING AN OUTLIER ADR
Once the affected ADR has (or have) been positively identified, it (they) should be switched OFF. This will trigger the corresponding ECAM warnings and associated drills, which should be followed to address all the consequences on the various aircraft systems.
In the extreme case where the affected ADR(s) cannot be identified or all speed indications remain unreliable, 2 ADRs should be selected OFF to prevent the flight control laws from using two coherent but unreliable ADR data. One must be kept ON to keep the stall warning protection. If at least one ADR remains reliable, the flight crew will use it (after having confirmed its validity), and so, will stop the application of the ADR CHECK PROC / UNRELIABLE SPEED INDICATION PROC.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A318/A319/A320/A321 機組訓練手冊 FCTM Flight Crew Training Manual(153)