曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

The rudder pedals must then be adjusted to ensure the pilot can achieve both full rudder pedal displacement and full braking simultaneously on the same side.
The armrest and the rudder pedals have position indicators. These positions should be noted and set accordingly for each flight.
MCDU USE
When clear for start up and taxi, the PF will preferably display the MCDU PERF TAKE OFF page whereas the PNF will display the MCDU F-PLN page.
 

  NORMAL OPERATIONS
PRE START
A318/A319/A320/A321
FLIGHT CREW TRAINING MANUAL 

Intentionally left blank
 

  NORMAL OPERATIONS
START
A318/A319/A320/A321
FLIGHT CREW TRAINING MANUAL 

ENGINE AUTO START
Criteria: SA
1 Applicable to: MSN 0045-0499
Engines usually start using the Automatic Starting function. The Full Authority Digital Engine Control (FADEC) systems control this engine Automatic Starting function, and takes appropriate action, if engine parameters are exceeded. This function extends significantly the duration of engine life.
The thrust levers must be confirmed at "idle" before engine-start. If the thrust levers are not at "idle", the thrust increases above idle after engine-start, and can result in a hazardous situation.
However, an ENG START FAULT ECAM warning triggers, to indicate that the flight crew must set the thrust levers to "idle".
The engines are started in sequence, preferably engine 2 first, in order to pressurize yellow hydraulic system, which supplies the parking brake accumulator.
When the ENG START selector is set to "START", the FADECs are electrically-supplied. When there is sufficient BLEED PRESS, the PF begins the start sequence by setting the ENG MASTER switch to ON. The flight crew should monitor the start sequence:
‐ Start valve opens
‐ N2 increases
‐ IGN A(B)
‐ Fuel flow
‐ EGT
‐ N1
‐ Oil pressure increases
‐ IGN indication off (Refer to FCOM/PRO-NOR-SOP-08 AUTOMATIC ENGINE START) ‐ Start valve closes
When the engine is at idle, or when AVAIL is displayed, the PF can start engine 1.
The flight crew should check the relative engine vibration level.
When the ENG START selector is set to NORM, the packs return to the OPEN position. APU Bleed should immediately be turned off, to avoid engine ingestion of exhaust gas.
If the start is not successful, the flight crew must use the ECAM as usually done, and avoid instinctively selecting the ENG MASTER switch to OFF. This would interrupt the FADEC protective actions (e. g. cranking after hot start).
ENGINE AUTO START
Criteria: CFMI, SA
2 Applicable to: MSN 1668-4078
Engines usually start using the Automatic Starting function. The Full Authority Digital Engine Control (FADEC) systems control this engine Automatic Starting function, and takes appropriate action, if engine parameters are exceeded. This function extends significantly the duration of engine life.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A318/A319/A320/A321 機組訓練手冊 FCTM Flight Crew Training Manual(55)