newton-meters).
 E. Put the Airplane Back to Its Usual Condition
 S 864-020
 (1)
Remove the DO-NOT-CLOSE tags and close these circuit breakers:

 (a)  
P6-2 Main Power Distribution Panel
 1) 6K18, APU ALTN CONT

 (b)  
P83 Aft APU Equipment Control and Circuit Breaker Panel 1) APU PRIME CONT

 S 864-021
 (2)  
Remove the DO-NOT-OPERATE tag from the APU control switch on the P5 overhead panel.

 S 414-022

 (3)  
Close the left APU access door, 317AL, and right APU access door, 318AR:

 (a)  
Remove the two quick-release pins, disconnect the two hold-open rods and put the two hold-open rods in the two clips on the right access door.

 (b)  
Install the two quick-release pins in the two brackets on the right APU compartment bulkhead.

 (c)  
Lift the right access door until you can install the lanyard on the pin at the aft APU compartment bulkhead.

 NOTE: The lanyard will hold the right access door on the
____
 APU compartment bulkhead.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
 49-52-05
 ALL  ú ú 05 Page 405 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 (d)  
Remove the two quick-release pins, disconnect the two hold-open rods and put the two hold-open rods in the two clips on the left access door.

 (e)  
Install the two quick-release pins in the two brackets on the left APU compartment bulkhead.

 (f)  
Make sure the insulation covers are correctly attach to the APU compartment firewall.

 (g)  
Lift the left access door until the two APU access doors are approximately aligned.

 (h)  
Close the two APU access doors.

 (i)  
Close the six latches on the right access door.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
 49-52-05
 ALL  ú ú 05 Page 406 ú Oct 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 DIVERTER VALVE MUFFLER - CLEANING/PAINTING
__________________________________________
 1.  General_______
 A.  This procedure gives the steps to clean the diverter valve muffler. The muffler must be removed for the procedure. The diverter vavle muffler is on the lower aft section of the engine. You can get access to the diverter valve muffler through the APU access doors.
 TASK 49-52-05-107-001
 2.  Clean Diverter Valve Muffler____________________________
 A.  Consumable Materials
 (1)  
B00148 Solvent - Methyl Ethyl Ketone (MEK), TT-M-261

 (2)  
G01043 Cloth - Lint-Free

 (3)  
B00338 Solvent - Acetone

 B.  
References

 (1)  
49-52-05/401, Diverter Valve Muffler

 C.  
Access

 (1)  
Location Zone 317 APU Compartment-Aft Lower Side of Engine, LH 318 APU Compartment-Aft Lower Side of Engine, RH

 (2)  
Access Panel
 317AL APU Access Door
 318AR APU Access Door

 D.  
Procedure

 S 027-002
 (1)  Remove the diverter valve muffler (AMM 49-52-05/401).
 S 117-003
 WARNING:_______DO NOT GET SOLVENT IN YOUR MOUTH, OR EYES, OR ON YOUR SKIN. DO NOT BREATHE THE FUMES FROM THE SOLVENT. PUT ON A PROTECTIVE SPLASH GOGGLE AND GLOVES WHEN YOU USE SOLVENT. KEEP SOLVENT AWAY FROM SPARKS, FLAME, AND HEAT. THE SOLVENT IS POISONOUS AND FLAMMABLE WHICH CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (2)  
Use a solvent with a lint free cloth to clean the inner and outer surfaces of the diverter valve muffler.

 (3)  
Let the diverter valve muffler dry completely.

 (4)  
Install the diverter valve muffler (AMM 49-52-05/401).

 S 117-004
 S 427-005
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 機載輔助動力 2(89)