(a)  
Do this task: APU Starting and Operation (AMM 49-11-00/201).

 (b)  
Operate the APU for a minimum of five minutes.

 (c)  
During the APU operation, examine the fuel metering unit for signs of fuel leakage.

 (d)  
If you find fuel leakage, then do these steps to repair the leakage: 1) Do this task: APU Usual Shutdown (AMM 49-11-00/201). 2) Attach a DO-NOT-OPERATE tag to the APU control switch on

 the P5 overhead panel. 3) Repair the cause of the fuel leakage. 4) Remove the DO-NOT-OPERATE tag from the APU control switch
 on the P5 overhead panel. 5) Do this task: APU Starting and Operation (AMM 49-11-00/201). 6) During the APU operation, examine the fuel metering unit for signs of fuel leakage. 7) If you find fuel leakage, do the leakage repair again.
 (e)  
If it is not necessary to do other tasks, do this task: APU Usual Shutdown (AMM 49-11-00/201).

 G.  
Put the Airplane Back to Its Usual Condition

 S 414-042
 (1)  
Close the left APU access door, 317AL, and right APU access door, 318AR:

 (a)  
Remove the two quick-release pins, disconnect the two hold-open rods and put the two hold-open rods in the two clips on the right access door.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
 49-31-01
 ALL  ú ú 03 Page 408 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 747-400 MAINTENANCE MANUAL
 (b) (c)  Install the two quick-release pins in the two brackets on the right APU compartment bulkhead.Lift the right access door until you can install the lanyard on the pin at the aft APU compartment bulkhead.
 NOTE:____ The lanyard will hold the right access door on the APU compartment bulkhead.
 (d)  Remove the two quick-release pins, disconnect the two hold-open rods and put the two hold-open rods in the two clips on the left access door.
 (e) (f) (g) (h) (i)  Install the two quick-release pins in the two brackets on the left APU compartment bulkhead.Make sure the insulation covers are correctly attach to the APU compartment firewall.Lift the left access door until the two APU access doors are approximately aligned.Close the two APU access doors.Close the six latches on the right access door.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
 49-31-01
 ALL  ú ú 03 Page 409 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 FUEL METERING ADAPTER - REMOVAL/INSTALLATION
____________________________________________
 1.  General_______
 A.  This procedure has these tasks:
 (1)  
A removal of the fuel metering adapter

 (2)  
An installation of the fuel metering adapter.

 B.  
You must remove the fuel metering unit to get access to the fuel metering adapter.

 TASK 49-31-02-004-001
 2.  Fuel Metering Adapter Removal (Fig. 401)_____________________________
 A.  References
 (1)  
AMM 49-31-01/401, Fuel Metering Unit

 B.  
Equipment

 (1)  
Container - Fuel Resistant, 1 U.S. Gallon (4 Liters)

 C.  
Access

 (1)  
Location Zones
 221 Control Cabin - Left
 222 Control Cabin - Right
 310 Fuselage - Station 2360 to Station 2792

 (2)  
Access Panels
 317AL APU Access Door - Left
 318AR APU Access Door - Right

 D.  
Procedure

 (1)
Do this task: Fuel Metering Unit Removal (AMM 49-31-01/401).

 S 024-037

 (2)  
Do these steps to remove the fuel metering adapter (1):

 (a)  
Put the container below the fuel metering adapter (1).

 (b)  
Disconnect the fuel supply tube (5) from the elbow (6).

 (c)  
Drain the fuel from the fuel supply tube (5) into the container.

 S 024-036
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 機載輔助動力 2(46)