ACCESS PANELS AND DOORS - REMOVAL/INSTALLATION
______________________________________________
TASK 57-51-37-000-002
R Removal of the Access Panels 573AB(673AB), 573BB(673BB), 573CB(673CB)
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______
GEAR.
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______
START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:
_______
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
-MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
1. Reason for the Job
__________________
R R Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific safety barriers
No specific warning notice
No specific adjustable access platform 4 m (13 ft. 1 in.)
98D27803500001 1 TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-00-00-480-002
27-50-00-866-009 57-51-37-991-003
3. Job Set-up
__________ R
Installation of the Flap/Slat Control-Lever Locking Tool (98D27803000000)Retraction of the Flaps on the GroundFig. 401
Subtask 57-51-37-941-052
R A. Safety Precautions R Put the safety barriers in position. R
R (1) Make sure that the flaps are fully retracted (Ref. TASK 27-50-00-866-009).
R (2) Install the TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER (98D27803500001) R on the flap/slat control lever (Ref. TASK 27-00-00-480-002).
R (3) Put the warning notice in the cockpit to tell persons not to operate R the flaps. R
Subtask 57-51-37-010-052
B. Get Access
(1) Put the adjustable access platform below the applicable access panel, zone 573(673).
4. Procedure
_________ R (Ref. Fig. 401/TASK 57-51-37-991-003) R Subtask 57-51-37-020-050
A. Removal of the Access Panels
(1)
For the access panel 573AB(673AB) (6):
(a) Release the nine camloc fasteners (5) then remove the access panel (6).
(2)
For the access panel 573BB(673BB) (4):
(a) Release the eight camloc fasteners (3) then remove the access panel (4).
(3)
For the access panel 573CB(673CB) (2):
(a) Release the five camloc fasteners (1) then remove the access panel (2).
R 1EFF : ALL 1 57-51-37Page 403 1 1 May 01/03 1 1 1CES 1
R R Lower Trailing Edge Access Panels - Rib 4 to Rib 8 Figure 401/TASK 57-51-37-991-003- 12 (SHEET 1)
1EFF : 1 1 1CES ALL 1 111 57-51-37 Page 404 Aug 01/02
R R Lower Trailing Edge Access Panels - Rib 4 to Rib 8 Figure 401/TASK 57-51-37-991-003- 22 (SHEET 2)
1EFF : 1 1 1CES ALL 1 111 57-51-37 Page 405 Aug 01/02
TASK 57-51-37-400-002
R Installation of the Access Panels 573AB(673AB), 573BB(673BB), 573CB(673CB)
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______
GEAR.
WARNING : MAKE SURE THAT THE FLIGHT CONTROL SAFETY-LOCKS AND THE WARNING
_______
NOTICES ARE IN POSITION.
CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:
_______
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼3(161)
