曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R  GEAR. 
R  1. Reason for the Job__________________ 
R  Refer to the MPD TASK: 575170-01 
R  2. Job Set-up Information______________________ 
R  A. Fixtures, Tools, Test and Support Equipment 
R  -------------------------------------------------------------------------------
R  REFERENCE  QTY DESIGNATION 
R  -------------------------------------------------------------------------------
R  No specific  safety barriers 
R  No specific  warning notices 
R  No specific  access platform 3 m (9 ft. 10 in.) 
R  98D27803500001  1 TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER 
R  B. Consumable Materials 
R  -------------------------------------------------------------------------------
R  REFERENCE  DESIGNATION 
R  -------------------------------------------------------------------------------
R  Material No. 11-026  GB  DEF-STAN  68-148/1 
R  SOLVENT GENERAL PURPOSE (Ref. 20-31-00) 
R  Material No. 19-003  USA AMS 3819 
R  LINT-FREE COTTON CLOTH (Ref. 20-31-00)

 

R C. Referenced Information
R -------------------------------------------------------------------------------R REFERENCE DESIGNATION R -------------------------------------------------------------------------------R Outer Wing, Top Skin External Surface, Aft of Rear Spar - Between RIB10 and R RIB20 at Buttstrap Attachments. R Figure 629/TASK 57-51-00-991-030
R  12-00-00-081-001  Removal of the Wing Safety Rope 
R  12-00-00-481-001  Installation of the Wing Safety Rope 
R  ASRM 572100  (for corrective action) 
R  57-51-00-991-030  Fig. 629 
R  3. Job Set-up__________ 
R  Subtask 57-51-00-941-085 
R  A. Safety Precautions 

R  (1) Put the safety barriers in position. 
R  (2) Install the TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER (98D27803500001) 
R  on the flap/slat control lever. 
R  (3) Put warning notices in the cockpit to tell persons not to operate the 
R  flaps or slats. 
R  (4) Put the access platform in position below zone 500(600). 
R  (5) Install the wing safety rope (Ref. TASK 12-00-00-481-001). 
R  4. Procedure_________ 
R  (Ref. Fig. 629/TASK 57-51-00-991-030) 
R  Subtask 57-51-00-110-093 
R  A. Preparation for Inspection 
R  (1) Use a clean MISCELLANEOUS (Material No. 19-003), made moist with 
R  CLEANING AGENTS (Material No. 11-026) to clean: 
R  - the wing top-skin aft of the rear spar, from RIB10 and RIB20 at the 
R  buttstrap attachments.

 

 1EFF : ALL 1 57-51-00Page A673 1 1 Feb 01/05 1 1 1CES 1

R Subtask 57-51-00-210-076

R  B. General Visual Inspection of the Outer Wing, Top Skin External Surface 
R  Aft of Rear Spar, Between RIB10 and RIB20 at Buttstrap Attachments. 
R  (1) Inspect the wing top-skin at the locations where the skin is attached 
R  to the buttstrap. Make sure that: 
R  - there is no corrosion 
R  - there are no cracks, dents, burrs, scores or scratches 
R  - the fasteners are in the correct condition 
R  - the surface protection is not damaged or loose. 
R  NOTE : If necessary, refer to the ASRM (Ref. ASRM 572100) for the____ 
R  correct repair procedure. 
R  5. Close-up________ 
R  Subtask 57-51-00-942-086 
R  A. Removal of Equipment 
R  (1) Remove the wing safety rope (Ref. TASK 12-00-00-081-001). 
R  (2) Remove the safety barriers. 
R  (3) Remove the warning notice(s). 
R  (4) Remove the access platform(s). 
R  (5) Remove the ground support and maintenance equipment, the special and 
R  standard tools and all other items.

 

 SHROUD BOX - REMOVAL/INSTALLATION
_________________________________
 TASK 57-51-15-000-001
 Removal of the Shroud Box 572(672)
 WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
 -
THE FLIGHT CONTROLS

 -
THE FLIGHT CONTROL SURFACES

 -
THE LANDING GEAR AND THE RELATED DOORS

 -COMPONENTS THAT MOVE.
 WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼3(121)