Subtask 57-51-00-865-079
 B. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
 1EFF : ALL 1 57-51-00Page 690 1 1 May 01/04R 1 1 1CES 1

 Outer-Wing Trailing-Edge, False Rear Spar - Forward and Aft Faces Figure 615/TASK 57-51-00-991-016
 1EFF : ALL 1 57-51-00Page 691 1 1 May 01/04R 1 1 1CES 1

 **ON A/C 001-049, 051-061, 101-103, 201-203,
 Subtask 57-51-00-010-067
 C. Get Access
 (1)
 Put the access platform below the applicable wing trailing edge at the false rear spar, zone 574(674).

 (2)
 Remove the applicable access panels (Ref. TASK 57-51-37-000-002):

 -
for the left wing, remove 573AB, 573BB, 573CB

 -
for the right wing, remove 673AB, 673BB, 673CB.

 (3)
 Open the applicable access panel:

 -for the left wing, open 574AB, 574BB
 -for the right wing, open 674AB, 674BB. R **ON A/C 062-099, 104-149, 151-199, 204-299, 301-399, 401-499,
 Subtask 57-51-00-010-067-A
 C. Get Access
 (1)
 Put the access platform below the applicable wing trailing edge at the false rear spar, zone 574(674).

 (2)
 Remove the applicable access panels:

 (a)
 For the left wing, remove:

 -573AB, 573BB, 573CB (Ref. TASK 57-51-37-000-002)
 -574AB, 574BB.

 (b)
 For the right wing, remove:

 -673AB, 673BB, 673CB (Ref. TASK 57-51-37-000-002)
 -674AB, 674BB.

 **ON A/C ALL
 4. Procedure
_________
 (Ref. Fig. 615/TASK 57-51-00-991-016)
 CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING
_______
 EDGE:

 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.

 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.

 -MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
 Subtask 57-51-00-110-087
 A. Preparation for Inspection
 (1) Use a MISCELLANEOUS (Material No. 19-003), made moist with CLEANING AGENTS (Material No. 11-026) to clean the forward and aft faces of the trailing-edge false rear spar.
 Subtask 57-51-00-210-056
 B. Inspection
 (1) Use a flashlight and a mirror to examine the forward and aft faces of the trailing-edge false rear spar. Make sure that:
 -
there are no cracks

 -
there is no damage

 -
there is no corrosion

 -the protective finish is in the correct condition.
 NOTE : If necessary, refer to the ASRM (Ref. ASRM 575100) for the
____
 correct repair procedure.

 1EFF : ALL 1 57-51-00Page 693 1 1 May 01/04R 1 1 1CES 1

 5. Close-up
________
 **ON A/C 001-049, 051-061, 101-103, 201-203,

 Subtask 57-51-00-410-067
 A. Close Access
 (1)
 Make sure that the work area is clean and clear of tool(s) and other items.

 (2)
 Install the applicable access panels (Ref. TASK 57-51-37-400-002):

 -
for the left wing, install 573AB, 573BB, 573CB

 -
for the right wing, install 673AB, 673BB, 673CB.

 (3)
 Close the applicable access panel:

 -for the left wing, close 574AB, 574BB
 -for the right wing, close 674AB, 674BB. R **ON A/C 062-099, 104-149, 151-199, 204-299, 301-399, 401-499,
 Subtask 57-51-00-410-067-A
 A. Close Access
 (1)
 Make sure that the work area is clean and clear of tool(s) and other items.

 (2)
 Install the applicable access panels:

 (a)
 For the left wing, install:

 -573AB, 573BB, 573CB (Ref. TASK 57-51-37-400-002)
 -574AB, 574BB.

 (b)
 For the right wing, install:

 -673AB, 673BB, 673CB (Ref. TASK 57-51-37-400-002)
 -674AB, 674BB.

 **ON A/C ALL

 Subtask 57-51-00-865-102
 B. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 6CV, 8CV.
 Subtask 57-51-00-942-066
 C. Removal of Equipment
 (1)
 Remove the access platform(s).
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼3(102)