-
a 40 micron filter,

 -
a servovalve of the deflection-jet type, equipped with a LVDT sensor which detects the position of the slide valve,

 -an adjustable diaphragm located on each output line of the servovalve, this diaphragm is used to adjust the flow to each actuating cylinder chamber and consequently the wheel steering speed,
 -a by-pass valve which interconnects the two chambers of the steering cylinder in the event of hydraulic system depressurization which may be due to: the loss of hydraulic power or the de-energization of the selector valve by the monitoring channel or the de-energization of the selector valve by the towing control lever on the electrical box,
 -when the hydraulic system is pressurized, the bypass valve can open for a pressure exceeding 273 bars. Any overpressure is then limited in the steering cylinder,
 -an anti-shimmy accumulator with a built-in pressure-relief valve, It can supply fluid pressurized to 15 bars in case of cavitation in one chamber of the cylinder, initiated by the shimmy.
 -two check valves which ensure the distribution of fluid from the
 accumulator to the chamber of the steering cylinder,

 -
a screw for the bleeding and/or depressurization of the hydraulic block,

 -
a non return valve allows pressurized fluid to flow in one direction.

 1EFF : 401-499, 1 32-51-00Page 24 1 1 Config-2 Aug 01/05 1 1 1CES 1

 Hydraulic BlocK
 Figure 015
 1EFF :  401-499,  1  32-51-00 Page 25 
1  1  Config-2 Aug 01/05
 1  1
 1CES  1

 G. Sensors 3GC (4GC)
 (Ref. Fig. 016)
 Two identical sensor boxes give the position of the rotating tube.
 The sensor box has a gear assembly with a sensor housing attached at the
 top by a clamping flange and four screws.
 The sensor box is shock-mounted to the landing gear strut.
 The sensor housing assembly contains an RVDT sensor.
 One sensor is part of the electrical channel of the steering control, the
 other sensor is part of the monitoring channel. These two sensors are
 supplied with 115 V from AC BUS 1 through the BSCU system 1.

 The gear assembly contains:

 -a reduction gear train
 -for maintenance only: a knob with a lockpin to lock the reduction gear in the neutral position (0 degree) before installation of the sensor box on the landing gear a worm screw to adjust the electrical 0 degree position with the sensor box installed on the landing gear.
 1EFF : 401-499, 1 32-51-00Page 26 1 1 Config-2 Aug 01/05 1 1 1CES 1

 Sensors
 Figure 016
 1EFF :  401-499,  1  32-51-00 Page 27 
1  1  Config-2 Aug 01/05
 1  1
 1CES  1

 H. Electrical Deactivation Box 5GC
 (Ref. Fig. 017)
 The electrical deactivation box permits isolation of the NWS system from
 the BSCU control.
 The box has two electrical connectors, a lever, an indicator (parking
 brake) and a P/BSW (light test) that are installed externally.
 When the lever is set to the TOWING, the NWS system is deactivated from
 the BSCU control. A safety pin locks the lever in the TOWING position.

 1EFF : 401-499, 1 32-51-00Page 28 1 1 Config-2 Aug 01/05 1 1 1CES 1

 Electrical Deactivation Box 5GC
 Figure 017

 1EFF : 401-499, 1 32-51-00Page 29 1 1 Config-2 Aug 01/05 1 1 1CES 1

 J. Swivel Selector Valve
 (Ref. Fig. 018)
 A swivel selector valve is installed co-axially with respect to the landing gear retraction axis. It provides the hydraulic interface between the aircraft and the landing gear. When the landing gear starts to retract, the swivel selector valve cuts the hydraulic power supply and connects the hydraulic block to the reservoir return line.
 1EFF : 401-499, 1 32-51-00Page 30 1 1 Config-2 Aug 01/05 1 1 1CES 1

 Swivel Selector Valve
 Figure 018

 1EFF : 401-499, 1 32-51-00Page 31 1 1 Config-2 Aug 01/05 1 1 1CES 1

 7. Operation/Control and Indicating
________________________________
 A. The hydraulic pressure is sent to the hydraulic block when the nose gear is extended.
 B. On the ground, when you open the NLG doors with the Ground Door-Opening Handle the steering is still operational. On the ground the energization of the selector valve causes the pressurization of the hydraulic block. This is done under the conditions below :
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LANDING GEAR 起落架8(74)