(4)
Install the guard assy (6) on the shroud (9) and joint.
NOTE : The debris guard has holes of different diameters :
____
-large diameter (two) : to put the locating pins in the correct position. Same holes on the shroud assy (centering function)
-small diameter (four) : to put the four attachment screws in the correct position.
1EFF : 051-099, 301-399, 401-499, 1 32-48-51Page 439 1 1 Aug 01/05 1 1 1CES 1 NOTE : Use the locating pins (2) to put the guard assy (6) in the
____
correct position.
NOTE : During the installation, be careful to correctly engage the
____
splines (1) in the guard assy (6).
(5) Install the screws (8) and the tab-washers (7) and then TORQUE the screws to between 1.6 and 1.9 m.daN (11.79 and 14.01 lbf.ft).
(6) Safety the screws (8) with the tab-washers (7). R **ON A/C 051-099, 301-399, 401-499,
Subtask 32-48-51-865-056
C. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
R **ON A/C 051-099, 301-399,
121VU HYDRAULIC/BRK FAN/WHEELS/3 AND 4 2GS L35 121VU HYDRAULIC/BRK FAN/WHEELS/1 AND 2 1GS L32 121VU HYDRAULIC/BRK/FAN/CTL 3GS M32
R **ON A/C 051-099, 301-399, 401-499,
Subtask 32-48-51-710-051
D. Operational Test
(1) Do the functional test of the brake fans (Ref. TASK 32-48-00-720-001).
1EFF : 051-099, 301-399, 401-499, 1 32-48-51Page 440 1 1 Aug 01/05 1 1 1CES 1
5. Close-up
________ Subtask 32-48-51-942-051
A. Removal of Equipment
(1)
Remove the warning notice(s).
(2)
Make sure that the work area is clean and clear of tool(s) and other items.
(3)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
1EFF : 051-099, 301-399, 401-499, 1 32-48-51Page 441 1 1 Aug 01/05 1 1 1CES 1 TIRE PRESSURE INDICATING SYSTEM (TPIS) - DESCRIPTION AND OPERATION
__________________________________________________________________
1. General_______ The system includes:
-
a sensor which measures the pressure of each tire,
-
a transmission unit which transmits the electrical pressure signal from the wheel (rotating) to the wheel axle (fixed). It includes a rotating transformer and an integrated electronic module,
-
a computer.
2. Component Location__________________ (Ref. Fig. 001, 002, 003)
-------------------------------------------------------------------------------FIN | FUNCTIONAL DESIGNATION | PANEL|ZONE|ACCESS | ATA | | | | DOOR | REF.
-------------------------------------------------------------------------------2GV DETECTOR UNIT-TPIS 94VU 122 811 32-49-34 4GV ROTATING MECH-TPIS NLG, WHEEL 1 711 32-49-17 5GV ROTATING MECH-TPIS NLG, WHEEL 2 711 32-49-17 6GV ROTATING MECH-TPIS MLG, WHEEEL 3 741 32-49-18 7GV ROTATING MECH-TPIS MLG, WHEEL 1 731 32-49-18 8GV ROTATING MECH-TPIS MLG, WHEEL 4 741 32-49-18 9GV ROTATING MECH-TPIS MLG, WHEEL 2 731 32-49-18 10GV PRESS XDCR-NLG, TIRE 1 711 32-49-15 11GV PRESS XDCR-NLG, TIRE 2 711 32-49-15 12GV PRESS XDCR-MLG, TIRE 3 741 32-49-16 13GV PRESS XDCR-MLG, TIRE 1 731 32-49-16 14GV PRESS XDCR-MLG, TIRE 4 741 32-49-16 15GV PRESS XDCR-MLG, TIRE 2 731 32-49-16
3. System Description__________________
A. Description
(Ref. Fig. 004)
(1) Sensor The sensor is installed in a support attached to the wheel rim. The sensor is of the piezoresistive strain-gage type. An external voltage source supplies this sensor which gives a DC signal from O to 100 mV in proportion to the pressure. A four-wire cable which is shielded and twisted connects the sensor to the transmission unit.
1EFF : 051-099, 1 32-49-00Page 1 1 1 May 01/05 1 1 1CES 1
TPIS Nose Wheel - Component Location
Figure 001
1EFF : 051-099, 1 32-49-00 Page 2
1 1 May 01/05
1 1
1CES 1
TPIS MLG Wheel - Component Location
Figure 002
1EFF : 051-099, 1 32-49-00 Page 3
1 1 May 01/05
1 1
1CES 1
TPIS - Component Location
Figure 003
1EFF : 051-099, 1 32-49-00 Page 4
1 1 May 01/05
1 1
1CES 1
TPIS - Main Gear wheel 中國航空網 m.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320飛機維護手冊 AMM LANDING GEAR 起落架8(47)
