曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R 
R  (d) Tiedown and Attachment Points 
R  The net tiedown and attachment points are installed in a 
R  designated and prearranged position on the aircraft structure and 
R  anchor plates. 
R  The tiedown and attachment points permit an easy and quick 
R  removal/installation of the nets without special tools. 
R 
R  (e) Passenger Oxygen Stowage 
R  The passenger oxygen stowage is installed on the right side of 
R  the Bulk cargo compartment , between FR62 and FR65. Sidewall 
R  linings are installed around the passenger oxygen-stowage rack. 
R

 

 Floor Protection Panels - FWD Cargo Compartment
 Figure 008

 CES

 Floor Protection Panels - AFT Cargo Compartment
 Figure 009

 CES

 LATCH - YZ FIXED - REMOVAL/INSTALLATION
_______________________________________ TASK 25-52-44-000-002 Removal of the Fixed YZ-Latch and YZ-Guide Rail
 1.
 Reason for the Job

__________________
 Self Explanatory

 2.
 Job Set-up Information

______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s)
 No specific warning notice(s)
 No specific access platform(s) 2.1 m (6 ft. 11 in.)

 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
52-30-00-860-001  Open the FWD or AFT Cargo-Compartment Door with the Yellow Electric Pump 53-42-14-000-001 Removal of the AFT Cargo-Compartment Floor-Panels Zone 150 25-52-44-991-001 Fig. 401
 3. Job Set-up
__________ Subtask 25-52-44-010-052
 A. Get Access
 (1)
 Open the FWD and/or AFT cargo compartment door and install the actuator safety locks (Ref. TASK 52-30-00-860-001).

 (2)
 Put the access platform(s) in position at the opening of the FWD and/or AFT cargo compartment door(s).

 (3)
 Put the warning notice(s) on the control panel of the cargo loading system to tell persons not to use it.

 

 Subtask 25-52-44-865-053
 B. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL SERVICE IDENT. LOCATION -------------------------------------------------------------------------------2000VU SEMI AUTO CLS-FWD 2MY B3 2000VU SEMI AUTO CLS-FWD 3MY B1 2001VU SEMI AUTO CLS-AFT 102MY E3 2001VU SEMI AUTO CLS-AFT 103MY E1
 Subtask 25-52-44-010-053
 C. For the AFT cargo compartment remove the floor panels (Ref. TASK 53-42-14-000-001) to gain access to the YZ-latches.
 4. Procedure
_________ Subtask 25-52-44-020-060
 A. Removal of the Fixed YZ-Latch and YZ-Guide Rail
 (Ref. Fig. 401/TASK 25-52-44-991-001)

 (1)
 Remove the YZ-guide rail.

 (a)
 Remove and discard the cotter pins (17).

 (b)
 Remove the connecting pins (16) from the YZ-guide rail (15).

 (c)
 Remove the YZ-guide rail (15).

 

 (2)
 Remove the YZ-latch with transport roller. NOTE : The bolts have different lengths. Write down their positions

____
 to make the installation easier.

 (a)
 Remove and discard the cotter pin (6).

 (b)
 Remove the spindle (7) from the transport roller (5).

 (c)
 Remove the transport roller (5).

 (d)
 In the AFT cargo compartment, remove the bolts (1) and the nuts

 (4) from the YZ-latch (8).

 (e)
 In the FWD cargo, compartment remove the bolts (1) from the YZ-latch (8).

 (f)
 Remove the YZ-latch (8) from the structure (3).

 

 Fixed YZ-Latch and YZ-Guide Rail Figure 401/TASK 25-52-44-991-001 
R  EFF :  001-049, 101-105,  25-52-44 Page 403 May 01/05
 CES 

 

 (3) Remove the fixed YZ-latch.
 (a)
 In the AFT cargo compartment, remove the nuts (4) and the bolts

 (1) from the YZ-latch (2).

 (b)
 In the FWD cargo compartment, remove the bolts (1) from the YZ-latch (2).
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EQUIPMENT/FURNISHINGS 設備3(154)