曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

27-21-00-840-801 Put the Rudder Hydraulic systems A, B, and Standby Back to the
Condition Before the Pressurization (P/B 201)
C. Location Zones
Zone Area
211 Flight Compartment - Left
212 Flight Compartment - Right
D. Procedure
SUBTASK 27-21-00-860-090-001
(1) Do this task: Rudder Hydraulic System A, B, or Standby Pressurization,
TASK 27-21-00-800-801.
SUBTASK 27-21-00-730-015-001
(2) Do the captain’s rudder pedal adjustment and the limit travel:
(a) Make sure the rudder trim indicator is at the zero unit of trim.
(b) Do these steps to set the jackshaft yoke to the middle position:
NOTE: The middle position of the jackshaft yoke is where the number of turns of the shaft
from the full forward and full aft adjustment are the same.
1) Turn the rudder pedal adjustment crank to move the rudder pedals full forward.
2) Turn the rudder pedal adjustment crank to move the rudder pedals full aft. Keep a
record of number of turns.
3) Turn the rudder pedal adjustment crank back half of the number of recorded turns to
set the jackshaft yoke to the middle position.
4) Make sure that you can install rig pins R-1 and R-2 easily.
(c) Turn the rudder pedal adjustment crank to move the captain’s pedals full forward.
(d) Push the captain’s left pedal until it touches the stop and hold.
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
EFFECTIVITY
GUN 001-005, 155-157, 201-999 PRE SB 737-27-1253 27-21-00
Config 1
Page 534
Jun 10/2007
D633A101-GUN
BOEING PROPRIETARY - Copyright#Unpublished Work - See title page for details
1) Measure the forward travel of the captain’s left pedal from the middle position of the
pedal adjustment.
2) Make sure the forward travel, which measured at the pedal pivot point is at a minimum
of 6.58 in. (167.1 mm).
3) Release the captain’s left pedal.
(e) Move the captain’s right pedal forward until it touches the stop and hold.
1) Measure the forward travel of the captain’s right pedal from the middle position of the
pedal adjustment.
2) Make sure the forward travel, which measured at the pedal pivot point is at a minimum
of 6.58 in. (167.1 mm).
3) Release the captain’s right pedal.
(f) Use the rudder pedal adjustment crank to move the captain’s pedals to full aft position.
(g) Push the captain’s left pedal until it touches the stop and hold.
1) Measure the aft travel of the captain’s right pedal from the middle position of the pedal
adjustment.
2) Make sure the aft travel, which measured at the pedal pivot point is at a minimum of
6.61 in. (167.9 mm).
3) Release the captain’s left pedal.
(h) Move the captain’s right pedal forward until it touches the stop and hold.
1) Measure the aft travel of the captain’s left pedal from the middle position of the pedal
adjustment.
2) Make sure the aft travel, which measured at the pedal pivot point is at a minimum of
6.61 in. (167.9 mm).
3) Release the captain’s right pedal.
SUBTASK 27-21-00-730-016-001
(3) Do the first officer’s rudder pedal adjustment and the limit travel:
(a) Make sure the rudder trim indicator is at the zero unit of trim.
(b) Set the pedals to the middle position.
1) Make sure that you can install rig pins R-1 and R-2 easily.
2) Keep a record of this middle position.
(c) Use the rudder pedal adjustment crank to move the first officer’s pedals full forward.
(d) Push the first officer’s left pedal until it touches the stop and hold.
1) Measure the forward travel of the first officer’s left pedal from the middle position of the
pedal adjustment.
2) Make sure the forward travel, which measured at the pedal pivot point is at a minimum
of 6.58 in. (167.1 mm).
3) Release the first officer’s left pedal.
(e) Move the first officer’s right pedal forward until it touches the stop and hold.
1) Measure the forward travel of the first officer’s right pedal from the middle position of
the pedal adjustment.
2) Make sure the forward travel, which measured at the pedal pivot point is at a minimum
of 6.58 in. (167.1 mm).
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
EFFECTIVITY
GUN 001-005, 155-157, 201-999 PRE SB 737-27-1253 27-21-00
Config 1
Page 535
Jun 10/2007
D633A101-GUN
BOEING PROPRIETARY - Copyright#Unpublished Work - See title page for details
3) Release the first officer’s right pedal.
(f) Use the rudder pedal adjustment crank to move the first officer’s pedals to full aft position.
(g) Push the first officer’s left pedal until it touches the stop and hold.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-600/700/800/900 AIRCRAFT MAINTENANCE MANUAL飛機維護手冊2(32)