(2)
Leakage of the seal in the VSCF will let oil flow from the VSCF to the spline cavity. The input shaft seal can be defective if these two indications occur after you fill the VSCF with oil:
(a)
The oil level in the VSCF decreases.
(b)
The oil level in the spline cavity increases.
B. Special Tools and Equipment
(1)
Service Cart - Malabar 53361-2, Malabar Hydraulics Co., 220 West Los Angeles Avenue, Simi Valley, CA 93065
(2)
Coupling - OMP2506-3, Ozone Metal Products, 101-32 101st Street, Ozone Park, Long Island, NY 11416
(3)
Spline Cavity Adapter - MS27404-3D, Aeroquip Corporation, Aerospace Division, 300 S. East Avenue, Jackson, MI 49203-1972.
C. Standard Tools and Equipment
(1) Bucket - to hold up to 2 gallons of used oil
D. Consumable Materials
(1) D00068 Oil - MIL-L-23699, MIL-L-7808, or any oil that agrees with the specifications of CFM56-3 SB79-001.
NOTE: Refer to the marker on the VSCF to find the oil that is in
____
the spline cavity.
E. References
(1) 71-11-02/201, Fan Cowl Panels
F. Access
(1)
Location Zones
506 Engine 1 - Accessory Gearbox, 8 o'clock
606 Engine 2 - Accessory Gearbox, 8 o'clock
(2)
Access Panels
5746L Left Fan Cowl - Engine 1
5737L Left Fan Cowl - Engine 2
G. Add Oil to the Spline Cavity.
S 493-070-003
(1)
Set the bucket below the accessory gearbox to catch the oil (if you did not do this before).
S 033-071-003
(2)
Remove the cap from the drain fitting for the spline cavity on the accessory gearbox (if you did not do this before).
NOTE: Use a second wrench to maintain the drain fitting during the
____
removal of the cap.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. -19 AND ON VARIABLE SPEED CONSTANT ú
12-13-21
FREQUENCY GENERATOR/CONVERTERS ú CONFIG 3 ú 01 Page 310 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
S 033-072-003
(3) Remove the cap from the pressure-fill valve for the spline cavity on
the VSCF.
S 493-073-003
(4) Connect the coupling to the pressure-fill valve for the spline
cavity.
S 823-074-003
(5) Set the pressure from the service cart to 25-40 psig.
S 613-075-003
(6) Fill the spline cavity until the oil starts to drain from the drain
fitting on the accessory gearbox.
(a) Let the oil drain until it stops.
S 093-076-003
(7) Disconnect the coupling from the pressure-fill valve for the spline
cavity.
S 433-077-003
(8) Install the cap on the pressure-fill valve for the spline cavity.
S 433-078-003
(9) Install the cap to the drain fitting for the spline cavity on the
accessory gearbox.
NOTE: Use a second wrench to maintain the drain fitting during the____
installation of the cap.
(a) Tighten the cap to a torque of 270-301 pound-inches.
(b) Install a lockwire.
S 093-079-003
(10) Remove the bucket.
(a) Discard the oil from the bucket.
S 163-080-003 CAUTION: IMMEDIATELY REMOVE ALL OF THE OIL THAT FALLS ON THE ENGINE
_______ PARTS. OIL CAN CAUSE DAMAGE TO THE PAINT AND SOME RUBBER PARTS.
(11)
Clean the engine parts that have oil on them. S 413-081-003
(12)
Close the left fan cowl on the applicable engine (Ref 71-11-02/201).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. -19 AND ON VARIABLE SPEED CONSTANT ú
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 SERVICING(51)
