Guidelines Summary: Ice, Snow or Frost Conditions
Figure 301 (Sheet 1)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
12-33-01
ALL ú ú 02 Page 305 ú Mar 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
G69249
A 737-300/400/500MAINTENANCE MANUAL
GUIDELINE TOPICS SUMMARY OF GUIDELINES
APU _______WARNING: PERSONS MUST STAY CLEAR OF THE DANGER AREAS IN FRONT OF THE APU INLET
AND IN BACK OF THE APU EXHAUST WHEN IT OPERATES. THE DANGER ZONE
GIVEN IN CHAPTER 10 MUST BE OBEYED.
APU CAN OPERATE WHEN DEICING BUT OBEY THE PRECAUTIONS
ENGINES PERSONS MUST STAY CLEAR OF THE DANGER AREAS IN FRONT OF THE ENGINE_______WARNING:
INLET AND IN BACK OF THE ENGINE EXHAUST WHEN THE ENGINE OPERATES. THE
DANGER ZONE GIVEN IN CHAPTER 10 MUST BE OBEYED.
DO NOT OPERATE ENGINES WHILE DEICING IF POSSIBLE
IF THE ENGINE MUST OPERATE WHILE DEICING, OBEY THE PRECAUTIONS
PRECAUTIONS DO NOT RELEASE THE AIRPLANE FOR TAKEOFF WITH ICE, SNOW OR FROST ON THE CONTROL
OR WING OR HORIZONTAL TAIL SURFACES EXCEPT FOR A MAXIMUM OF 1/8-INCH FROST ON
THE LOWER WING SURFACE BETWEEN THE SPARS.
FUSELAGE AND VERTICAL TAIL SURFACES MUST BE FREE FROM ICE AND SNOW. THIN
HOAR FROST IS PERMITTED ON THE TOP OF THE FUSELAGE.
DO NOT POINT THE SPRAY OF DEICING/ANTI-ICING FLUID DIRECTLY INTO THE ENGINE OR
APU INLETS, EXHAUSTS, ENGINE THRUST REVERSERS, PROBE INLETS, SCOOPS, VENTS,
DRAINS, ETC.
DO NOT POINT THE SPRAY OF HOT FLUID DIRECTLY ON THE WINDOWS WHEN THEY ARE COLD.
DO NOT PUSH ICE OR SNOW INTO THE OPENINGS AROUND THE FLIGHT CONTROL SURFACES
DURING THE REMOVAL PROCEDURE.
DO NOT CLOSE A DOOR UNTIL YOU REMOVE ALL OF THE ICE OR SNOW WITH DEICING
FLUID.
CLOSE THE VALVES FOR THE AIR CONDITIONING PACKS AND BLEED VALVES IF THE ENGINES
OR APU WILL OPERATE.
INSPECTION FOR OPERATE ALL OF THE CONTROL SURFACES THROUGH THEIR FULL CYCLE. USE A PERSON
OPERATION ON THE GROUND TO MAKE SURE THE CONTROL SURFACES MOVE FULL TRAVEL. IF YOU
THINK THAT SEALS ARE FROZEN OR THERE ARE BLOCKAGES, THEN MOVE THE CONTROL
SURFACES MANUALLY BEFORE YOU APPLY POWER.
MAKE SURE THE PITOT AND STATIC OPENINGS ARE FREE OF BLOCKAGES AT LEAST 4 FEET
AWAY.
MAKE SURE THERE IS NO ICE, SNOW OR SLUSH COLLECTED ON THE LANDING GEAR OR IN
THE WHEEL WELL AREA.
MAKE SURE THAT ALL THE INLETS AND EXHAUSTS ARE NOT BLOCKED.
MAKE SURE THAT ALL THE DRAINS ARE CLEAR AND NOT BLOCKED.
MAKE SURE THE ANGLE OF AIRFLOW SENSORS ARE CLEAR OF ICE AND/OR SNOW AND THAT
THE SENSORS MOVE FREELY.
Guidelines Summary: Ice, Snow or Frost Conditions
Figure 301 (Sheet 2)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
12-33-01
ALL ú ú 02 Page 306 ú Mar 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
G69250
A 737-300/400/500MAINTENANCE MANUAL
(d)
There is only snow on the airplane.
(e)
The temperature is 34 F or higher, and stable or on the increase.
CAUTION: DO NOT POINT A SOLID FLOW OF FLUID DIRECTLY AT THE
_______ SURFACE. APPLY THE FLUID AT LOW ANGLE TO PREVENT DAMAGE TO THE AIRPLANE SURFACES. DO NOT USE A HIGH PRESSURE SPRAY TO BLOW THE ICE AND SNOW OFF THE AIRPLANE SURFACES.
(f)
For the best results in the ice or snow removal, you must increase the temperature of the deicing fluid and hot water to 180-200 F, at the tank. A fine to medium spray is recommended to apply the fluid across a large area of ice or snow. This will cause the ice or snow to melt the fastest. A solid flow of fluid is recommended to flush the ice or snow from the airplane surfaces. Make sure the maximum force of the solid flow of fluid on the surfaces in not more than 10 psi on an area of 25 square inches. This will prevent damage to the surfaces.
(g)
To find the quantaity of deicing/anti-icing fluid to use in the deicing mixture at a given temperature, refer to the airline procedure or the manufacturter's specifications for the fluid you use. For Type I fluids use Figure 302 in this document. For Type II and Type IV fluids also use Figure 302. The lower of the ambient temperature or the temperature of the airplane surface is the temperature to use for the Table. See if the mixture of melted ice or snow and deicing/anti-icing fluid freezes again on the airplane as it flows off. If it does, a larger quantity of deicing/anti-icing fluid in the mixture is necessary.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 SERVICING(156)
