(10)
 Disconnect the ground cables for the airplane.

 (11)
 Close the access door for the refuel panel.

 S 083-099
 S 083-100
 S 413-101
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 12-11-04
 ALL  ú ú 02 Page 308 ú Mar 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 813-102
 (12) At the first maintenance opportunity, do this task:  Pressure Fueling System - Troubleshooting (AMM 28-21-00/101), Procedure 3, Fuel Does Not Flow Into the NO. 1 tank, the No. 2 tank, or the center tank.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 12-11-04
 ALL  ú ú 01 Page 309 ú Mar 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 HYDRAULIC RESERVOIR - SERVICING
_______________________________
 TASK 12-12-00-613-001
 1. Hydraulic Reservoir Servicing
_____________________________
 A. General
 (1)  
If the complete loss of hydraulic fluid has occured, accomplish Hydraulic Fluid Replacement procedure (AMM 29-00-00/201).

 (2)  
If the hydraulic reservoir was filled after the replacement of a component or after fluid loss, accomplish Bleed the Hydraulic System procedure (AMM 29-00-00/201).

 (3)  
The equipment that is necessary to fill the hydraulic fluid is on the forward bulkhead of the right wheel well. The equipment includes a hand pump, a pressure fill connection, a filter for the hydraulic fluid, and a selector valve.

 (4)  
There is a fluid quantity indicator on the system A and B reservoirs. The system B reservoir is filled through the standby reservoir. When the fluid quantity indicator for system B shows full, the system B reservoir and the standby reservoir are full.

 (5)  
The fluid chilling at high altitude and the large ambient temperature changes between departure and arrival locations can result in a decrease in fluid levels. These cold soak effects will not have an impact on the operation of the systems but it can shrink the fluid sufficiently to indicate a need for servicing, even if you serviced the reservoirs at a warm location before the previous flight. Under such circumstances, if you service the airplane "high" at the cold location before the airplane is sent back to the warm location, it is possible that you will cause an overfill of the reservoir and fluid can overflow from the drain line.

 (6)  
If the ambient temperature on the ground is 20° F or lower at an arrival location and a fluid level is below "REFILL", service the reservoir to just above "REFILL" to avoid the overflow of fluid at the next warmer location.

 B. Reference
 (1) AMM 29-09-00/201, Hydraulic Reservoirs Pressurization System
 C. Consumable Materials
 (1)  D00153 Hydraulic Fluid BMS 3-11
 D. Access
 (1)  Location Zones
 217 Right Main Wheel Well

 E. Hydraulic Reservoir Servicing Procedure
 S 863-002
 (1)  Remove hydraulic power (AMM 29-15-00/201).
 NOTE: It is not necessary to remove the air pressure from the
____ hydraulic reservoirs before you fill them.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 12-12-00
 ALL  ú ú 03 Page 301 ú Jul 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL 
SELECTOR VALVE ASEE (SHOWN CLOSED) 
PUMP HAND  FILL CONNECTION PRESSURE 
FILTER 
FWD 
OF THE RIGHT WHEEL WELL LOCATED ON THE FORWARD BULKHEAD  SUCTION HOSE AIRPLANE) (REMAINS WITH 

TO SYSTEM A 
RESERVOIR 
FILL 
SUPPLY 
TO STANDBY AND 
SYSTEM B 
RESERVOIRS  FWD 
A 
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 SERVICING(27)