R  Sliding Windows - Lining Panels 
R  Figure 402/TASK 56-12-11-991-033 
R 1EFF :  051-099,  1  56-12-11 Page 405 
1  1  May 01/05
 1  1
 1CES  1

R  (d) Loosen the clamp (28) and disconnect the duct (27). 
R  (e) Remove the lining panel (29) 211KC (212KC). 
R  (3) Removal of the sliding window lining (16) 
R  (a) Open the sliding window 8DG1 (8DG2) (Ref. TASK 56-12-11-010-001). 
R  (b) Remove the screw (5) and remove the pencil holder assembly (7). 
R  (c) Remove the screw (21) and the washer (20). 
R  (d) Remove the screw (19) and the washer (18). 
R  (e) Remove the handle (6). 
R  (f) Remove the screw (9) and the washer (8). 
R  (g) Remove the screw (15) and the washer (14). 
R  (h) Close the sliding window. 
R  (i) Remove the blanking plug (4), remove the screw (3) and the washer 
R  (2). 
R  (j) Remove the screws (11). 
R  (k) Remove the screws (12). 
R  (l) Lift the plate (17) and remove the sliding window lining (16). 
R  (m) Disconnect the electrical connector (10) from the receptacle. 
R  (n) Put blanking caps on the disconnected electrical connectors. 
R  Subtask 56-12-11-020-058 
R  B. Removal of the Aft Upper Rail 
R  (Ref. Fig. 403/TASK 56-12-11-991-032) 
R  (1) Remove the bolts (54),(55) and the nuts (57). 
R  (2) Remove the aft upper rail (56) from its support. 

R 1EFF : 051-099, 1 56-12-11Page 406 1 1 May 01/05 1 1 1CES 1

R  Sliding Windows - Removal/Installation 
R  Figure 403/TASK 56-12-11-991-032 
R 1EFF :  051-099,  1  56-12-11 Page 407 
1  1  May 01/05
 1  1
 1CES  1

R Subtask 56-12-11-020-059

R  C. Removal of the Sliding Window 
R  CAUTION : BE CAREFUL WHEN YOU REMOVE THE SLIDING WINDOW.THE HANDLE IS_______ 
R  SPRING -LOADED AND WILL MOVE SUDDENLY WHEN YOU REMOVE THE 
R  WINDOW FROM THE TRACK. IF YOU ARE NOT CAREFUL THE HANDLE CAN 
R  HIT YOU. 
R  (1) Move the sliding window assembly until it touches the rear stop. Then 
R  remove it. 
R  Subtask 56-12-11-110-057 
R  D. Cleaning 
R  WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL_______ 
R  MATERIALS ONLY WITH A GOOD SUPPLY OF AIR. 
R  OBEY THE MANUFACTURERS INSTRUCTIONS. 
R  PUT ON PROTECTIVE CLOTHING. 
R  DO NOT GET THEM IN YOUR MOUTH. 
R  DO NOT SMOKE. 
R  DO NOT BREATHE THE GAS. 
R  THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. 
R  GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED. 
R  (1) Remove the sealant with a non-metallic scraper from the aft upper 
R  rail (56) and from its support. 
R  (2) Clean the aft upper rail (56) and its support with the CLEANING 
R  AGENTS (Material No. 11-003) and MISCELLANEOUS (Material No. 19-003). 

R 1EFF : 051-099, 1 56-12-11Page 408 1 1 May 01/05 1 1 1CES 1

R TASK 56-12-11-400-001-A

R Installation of the Sliding Windows R WARNING : MAKE SURE THAT THE CIRCUIT BREAKERS RELATED TO THE WEATHER RADAR ARE
_______ R OPENED, SAFETIED AND TAGGED.
R 1. Reason for the Job
__________________
R This procedure is applicable to the glass windows (SPS supplier, P/N R SPS...). R 2. Job Set-up Information
______________________
R A. Fixtures, Tools, Test and Support Equipment
R -------------------------------------------------------------------------------R REFERENCE QTY DESIGNATION
R -------------------------------------------------------------------------------
R No specific dynamometer 25 daN (56.2022 lbf)
R No specific Torque Wrench : range 0.00 to 1.20 m.daN
R (0.00 to 9.00 lbf.ft)

R B. Consumable Materials

R -------------------------------------------------------------------------------R REFERENCE DESIGNATION
R -------------------------------------------------------------------------------
R Material No. 04-004 R R R Material No. 08-002A R R Material No. 09-019 R R R Material No. 19-010 R R USA MIL-PRF-23827 TYPE I SYNTH.ESTER BASED GREASE HIGH PRESSURE (Ref. 20-31-00)
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINDOWS 風擋 窗戶(49)