曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 -------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
 -------------------------------------------------------------------------------
No specific access platform 2.0 m (6 ft. 7 in.)
R No specific Torque Wrench : range 0.00 to 1.20 m.daN
R (0.00 to 9.00 lbf.ft)
 B. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE DESIGNATION
 -------------------------------------------------------------------------------
52-30-00-860-001 Open the FWD or AFT Cargo-Compartment Door with the Yellow Electric Pump 52-30-00-860-002 Close the FWD or AFT Cargo-Compartment Door with the
 Yellow Electric Pump 52-31-00-710-001 Operational Test of the FWD Cargo-Compartment Door 52-31-11-000-001 Removal of the FWD Cargo-Compartment Door 52-31-11-400-002 Installation of the FWD Cargo-Compartment Door 52-31-31-000-001 Removal of the Stop Bolts 52-31-31-400-001 Installation of the Stop Bolts 52-31-32-400-001 Installation of the Lock Fitting Components
R **ON A/C 001-049, 051-099, 101-105, 151-199, 201-220,
 52-31-11-991-007 Fig. 501
 1EFF : ALL 1 52-31-11Page 501 1 1 May 01/05 1 1 1CES 1 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------

R **ON A/C 106-149, 221-299, 301-399, 401-499,
 52-31-11-991-007-A Fig. 501A
 **ON A/C 001-049, 051-099, 101-105, 151-199, 201-220,

 52-31-11-991-008 Fig. 502 R **ON A/C 106-149, 221-299, 301-399, 401-499,
 52-31-11-991-008-A Fig. 502A
 **ON A/C ALL

 3. Job Set-up
__________
 Subtask 52-31-11-010-057

 A. Get Access NOTE : You must do the door measurement under the subsequent conditions:
____ -A/C on Landing Gears or Jacks.
 -Cargo Compartments unloaded.
 -Fuel Tanks defueled.
 -Air Condition System depressurized.
 (1)
 Make sure that the FWD cargo compartment door (referred to as cargo door) is correctly closed and locked (Ref. TASK 52-30-00-860-002).

 (2)
 Put the access platform in position below the closed cargo door.

 (3)
 Remove the access panel 825AR from the cargo door.

 1EFF : ALL 1 52-31-11Page 502 1 1 Aug 01/05 1 1 1CES 1

 4. Procedure
_________
 Subtask 52-31-11-820-051

 A. Adjustment of the lateral gaps "A" thru "F"
 **ON A/C 001-049, 051-099, 101-105, 151-199, 201-220,

 (Ref. Fig. 501/TASK 52-31-11-991-007) R **ON A/C 106-149, 221-299, 301-399, 401-499,
 (Ref. Fig. 501A/TASK 52-31-11-991-007-A)
 **ON A/C 001-049, 051-099, 101-105, 151-199, 201-220,

 (Ref. Fig. 502/TASK 52-31-11-991-008) R **ON A/C 106-149, 221-299, 301-399, 401-499,
 (Ref. Fig. 502A/TASK 52-31-11-991-008-A)
 **ON A/C ALL

 (1)
 Measure the lateral gaps "A" thru "F" between the cargo door and the door frame.

 (2)
 If these gaps are larger or smaller than permitted, remove the end fitting from the piano hinge area (Ref. TASK 52-31-11-000-001).

 (3)
 Change the thickness of the adjustment washers between the two piano hinge halves of FR26A and FR26.

 (4)
 Make sure that the lateral gaps "A" thru "F" are correct.

 (5)
 Install the end fittings to the piano hinge area (Ref. TASK 52-31-11-400-002).

 1EFF : ALL 1 52-31-11Page 503 1 1 Aug 01/05 1 1 1CES 1

 Lateral Gaps - FWD Cargo Door/Fuselage
 Figure 501/TASK 52-31-11-991-007

R 1EFF : 001-049, 051-099, 101-105, 151-199, 1 52-31-11Page 504 1201-220, 1May 01/05 1 1 1CES 1

 Lateral Gaps - FWD Cargo Door/Fuselage
 Figure 501A/TASK 52-31-11-991-007-A

R 1EFF : 106-149, 221-299, 301-399, 401-499, 1 52-31-11Page 505 1 1 Aug 01/05 1 1 1CES 1

 Skin Offset - FWD Cargo Door/Fuselage
 Figure 502/TASK 52-31-11-991-008

R 1EFF : 001-049, 051-099, 101-105, 151-199, 1 52-31-11Page 506 1201-220, 1May 01/05 1 1 1CES 1 Skin Offset - FWD Cargo Door/Fuselage Figure 502A/TASK 52-31-11-991-008-A

R 1EFF : 106-149, 221-299, 301-399, 401-499, 1 52-31-11Page 507 1 1 Aug 01/05 1 1 1CES 1

R  **ON A/C 001-049, 053-099, 101-149, 151-199, 201-299, 301-399, 401-499,
 Subtask 52-31-11-820-062-A
 B. Adjustment of the Skin Offset
 **ON A/C 001-049, 053-099, 101-105, 151-199, 201-220,
 (Ref. Fig. 502/TASK 52-31-11-991-008) 
R  **ON A/C 106-149, 221-299, 301-399, 401-499,
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門4(49)