曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R  **ON A/C 106-149, 221-299, 301-399, 401-499,
 52-31-21-991-015-A Fig. 413A **ON A/C 001-049, 053-099, 101-105, 151-199, 201-220,
R  52-31-21-991-016 Fig. 414 **ON A/C 106-149, 221-299, 301-399, 401-499,
R  52-31-21-991-016-A Fig. 414A **ON A/C 001-049, 053-099, 101-149, 151-199, 201-299, 301-399, 401-499,
 3. Job Set-up__________ Subtask 52-31-21-010-068
 A. Get Access
 **ON A/C 001-049, 053-099, 101-105, 151-199, 201-220,
R  (Ref. Fig. 412/TASK 52-31-21-991-021) **ON A/C 106-149, 221-299, 301-399, 401-499,
R  (Ref. Fig. 412A/TASK 52-31-21-991-021-A) **ON A/C 001-049, 053-099, 101-149, 151-199, 201-299, 301-399, 401-499,
 (1) Open the FWD cargo-compartment door (referred to as cargo door) and safety the the cargo door with the actuator safety locks (Ref. TASK 52-30-00-860-001). (2) Remove the access panel 825AR from the cargo door. 

R 1EFF : 001-049, 053-099, 101-149, 151-199, 1 52-31-21Page A464 1201-299, 301-399, 401-499, 1Aug 01/05 1 1 1CES 1

 Access Cover and Protection Plugs R Figure 412/TASK 52-31-21-991-021
 1EFF : 001-049, 053-099, 101-105, 151-199, 1 52-31-21Page A465 1201-220, 1May 01/05 1 1 1CES 1

 Access Cover and Protection Plugs Figure 412A/TASK 52-31-21-991-021-A
R 1EFF : 106-149, 221-299, 301-399, 401-499, 1 52-31-21Page A466 1 1 Aug 01/05 1 1 1CES 1

 (3)
 Put the access platform in position below the opened cargo door.

 (4)
 Remove the screws (3) and (4) and the washer (2) and the access panel from the inner skin of the cargo door.

 (5) Remove the protection plug (5) from the edge member FR28.
 Subtask 52-31-21-865-074

 B. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
121VU HYDRAULIC/HYD POWER/Y 3803GX N30 122VU DOORS/CARGO 1MJ T12 123VU Y HYD/ELEC/PUMP 3802GX AB06 123VU Y HYD/ELEC/ELEC PUMP/NORM 3801GX AB03
 4. Procedure
_________
 **ON A/C 001-049, 053-099, 101-105, 151-199, 201-220,

 (Ref. Fig. 413/TASK 52-31-21-991-015) R **ON A/C 106-149, 221-299, 301-399, 401-499,
 (Ref. Fig. 413A/TASK 52-31-21-991-015-A)
 **ON A/C 001-049, 053-099, 101-105, 151-199, 201-220,

 (Ref. Fig. 414/TASK 52-31-21-991-016) R **ON A/C 106-149, 221-299, 301-399, 401-499,
 (Ref. Fig. 414A/TASK 52-31-21-991-016-A)
R 1EFF : 001-049, 053-099, 101-149, 151-199, 1 52-31-21Page A467 1201-299, 301-399, 401-499, 1Aug 01/05 1 1 1CES 1

 Door Handle R Figure 413/TASK 52-31-21-991-015
 1EFF : 001-049, 053-099, 101-105, 151-199, 1 52-31-21Page A468 1201-220, 1May 01/05 1 1 1CES 1

 Door Handle Figure 413A/TASK 52-31-21-991-015-A
R 1EFF : 106-149, 221-299, 301-399, 401-499, 1 52-31-21Page A469 1 1 Aug 01/05 1 1 1CES 1

 Linkage Mechanism R Figure 414/TASK 52-31-21-991-016
 1EFF : 001-049, 053-099, 101-105, 151-199, 1 52-31-21Page A470 1201-220, 1May 01/05 1 1 1CES 1

 Linkage Mechanism Figure 414A/TASK 52-31-21-991-016-A
R 1EFF : 106-149, 221-299, 301-399, 401-499, 1 52-31-21Page A471 1 1 Aug 01/05 1 1 1CES 1R **ON A/C 001-049, 053-099, 101-149, 151-199, 201-299, 301-399, 401-499,

 Subtask 52-31-21-020-070
 A. Removal of the Door Handle
 (1)
 Make sure that the door handle (14) is in the UNLOCKED position.

 (2)
 Install a mounting nut (e.g. NAS 509-4) (18) on the spring bolt (19) to keep the handle spring (20) in position.

 (3)
 Remove the control rod (57) from the shaft lever (25) as follows:

 (a)
 Remove and discard the cotter pin (61) from the nut (60).

 (b)
 Remove the nut (60), washers (59) and the bolt (58).

 (c)
 Disconnect the fork-end of the control shaft (57) from the shaft lever (25).

 

 (4)
 Remove the connection rod (45) from the Maltese-cross latch (32) as follows:

 (a)
 Remove and discard the cotter pin (46) from the nut (47).

 (b)
 Remove the nut (47), washers (48) and the bolt (49).

 (c)
 Disconnect the fork-end of the connection rod (45) from the Maltese-cross latch (32).

 

 (5)
 Remove the door handle (14) from the door structure (17) as follows:

 (a)
 Remove the screws (29) and the lock device (30) from the door structure (17).

 (b)
 Carefully move the door handle shaft (26) in the rear direction.

 (c)
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門4(132)