-COMPONENTS THAT MOVE.
 WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______
 GEAR.

 CAUTION : MAKE SURE THAT THE RIGGING PINS ARE REMOVED BEFORE OPERATION OF THE
_______ FREE FALL SYSTEM. DAMAGE WILL OCCUR IF THE RIGGING PINS ARE INSTALLED DURING SYSTEM OPERATION.
 1. Reason for the Job
__________________
 Refer to the MPD TASK: 323300-02
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific safety barriers
 No specific spring balance 5.0 daN (12 lbf)
 No specific warning notice

R  D23080000 1 GROUND SAFETY LOCK 460005833 2 GROUND LOCK SLEEVE 460005835 1 GROUND LOCK SLEEVE 460007280 2 GROUNDLOCK SLEEVE
 1EFF : ALL 1 32-33-00Page 501 1 1 Aug 01/05 1 1 1CES 1

 B. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE DESIGNATION
 -------------------------------------------------------------------------------
07-11-00-581-001 Lifting for Aircraft Maintenance Operations 07-11-00-586-002 Lowering of the Aircraft for Maintenance Operations 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
 from the External Power 29-10-00-863-001 Pressurize the Green Hydraulic System 29-10-00-864-001 Depressurize the Green Hydraulic System 31-60-00-860-001 EIS Start Procedure 32-00-00-481-001 Installation of the Safety Devices on the Landing
 Gears 32-00-00-481-002 Installation of the Safety Devices on the Landing
 Gear Doors
R 32-00-00-860-001 Flight Configuration Precautions with Electrical
R Power
R 32-00-00-860-002 Ground Configuration after Flight Configuration with
R Electrical Power 32-12-00-010-001 Open the Main Gear Doors for Access 32-12-00-410-001 Close the Main Gear Doors after Access 32-22-00-010-001 Nose Gear Doors - Ground Doors Opening 32-22-00-410-001 Nose Gear Doors - Ground Doors Closing 34-10-00-860-002 ADIRS Start Procedure 34-10-00-860-005 ADIRS Stop Procedure 32-33-00-991-001 Fig. 501
 3. Job Set-up
__________
 (Ref. Fig. 501/TASK 32-33-00-991-001)
 Subtask 32-33-00-941-050
 A. Safety Precautions
 (1)
 Put the safety barriers in position.

 (2)
 Make sure that the ground safety locks are on the landing gear (Ref. TASK 32-00-00-481-001).

 (3)
 On the panel 400VU:

 -make sure that the landing-gear control-lever 6GA is in the DOWN position
 -put a warning notice in position to tell persons not to operate the landing gear.
 1EFF : ALL 1 32-33-00Page 502 1 1 Nov 01/04 1 1 1CES 1

 Free-Fall Extension - Controls and Indications
 Figure 501/TASK 32-33-00-991-001
 1EFF :  ALL  1  32-33-00 Page 503 
1  1  Feb 01/98
 1  1
 1CES  1

 (4)
 On the panel 110VU, make sure that the GRAVITY GEAR EXTN handle is folded into the center console.

 (5)
 Put a warning notice in position to tell persons not to pressurize the hydraulic systems.

 Subtask 32-33-00-582-050
 B. Lift the Aircraft
 (1) Lift the aircraft on jacks (Ref. TASK 07-11-00-581-001).
 Subtask 32-33-00-869-079

 C. Flight Configuration Precautions
 (1) If the electrical power is necessary, do the precautions for flight configuration (Ref. TASK 32-00-00-860-001) before you open the LGCIU circuit breakers.
 Subtask 32-33-00-865-073
 D. Make sure that this(these) circuit breaker(s) is(are) closed:
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FWS/FWC1/SPLY 3WW F01 121VU EIS/FWC2/SPLY 2WW Q07
 Subtask 32-33-00-080-052
 E. Removal of Safety Equipment R (1) Remove the GROUND SAFETY LOCK from the NLG.
 (2) Remove the GROUND LOCK SLEEVE (460005833) or the GROUNDLOCK SLEEVE (460007280) from each MLG lockstay actuator.
 Subtask 32-33-00-865-050
 F. Make sure that this(these) circuit breaker(s) is(are) closed:
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
49VU L/G/LGCIU/SYS1/NORM 1GA C09 121VU HYDRAULIC/LGCIU/SYS2 2GA Q35 121VU HYDRAULIC/LGCIU/SYS1/GRND SPLY 52GA Q34
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LANDING GEAR 起落架5(96)