曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

NOTE: The bolt assembly [112] is installed through the circular access hole in the
tailcone.
2) Tighten the nut [111] to 500 - 600 pound-inches (56.5 - 67.8 newton-meters).
CAUTION: DO NOT TIGHTEN THE NUT [111] AGAIN AFTER YOU TIGHTEN THE NUT
[110], YOU CAN CAUSE DAMAGE TO EQUIPMENT.
3) Install the nut [110].
4) Tighten the nut [110] to 150 - 220 pound-inches (17.0 - 24.9 newton-meters).
SUBTASK 27-31-11-080-003
(3) If you used the sling, SPL-2034 to support the elevator assembly, do the following to remove the
sling, SPL-2034 from the elevator installation [1] (Figure 403):
(a) Remove the fasteners to disconnect the forward sling fittings from the elevator
installation [1].
(b) Remove the forward sling fittings from the elevator installation [1].
(c) Install the bolts [3] on the elevator installation [1].
(d) Remove the aft sling fitting from the elevator installation [1].
SUBTASK 27-31-11-860-009
(4) Remove the safety tag and close this circuit breaker:
CAPT Electrical System Panel, P18-2
Row Col Number Name
C 8 C00544 FLIGHT RECORDER POSITION SENSOR
SUBTASK 27-31-11-820-008
(5) Do this task: Elevator Control Pushrods - Adjustment, TASK 27-31-00-820-802.
SUBTASK 27-31-11-700-001
(6) Do this task: Input Rods of the Elevator Power Control Unit - Adjustment,
TASK 27-31-00-820-803.
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
EFFECTIVITY
GUN ALL 27-31-11
Page 437
Oct 10/2005
D633A101-GUN
BOEING PROPRIETARY - Copyright#Unpublished Work - See title page for details
SUBTASK 27-31-11-700-002
(7) Do this task: Elevator Tab Pushrods - Adjustment, TASK 27-31-00-820-805.
SUBTASK 27-31-11-820-009
(8) Do this task: Elevator Position Transmitter Installation Test, TASK 31-31-51-700-801.
SUBTASK 27-31-11-710-023
(9) Do this task: Manual Mode - Test, TASK 27-31-00-700-807.
NOTE: After completing the Manual Mode Test, and while the hydraulics are still pressurized,
check the hydraulic connection on the elevator tab mechanism actuator for hydraulic
fluid leaks.
SUBTASK 27-31-11-710-013
(10) Do this task: Elevator Surface Friction and Balance - Test, TASK 27-31-00-700-802.
SUBTASK 27-31-11-710-014
(11) Do this task: Elevator Travel Limit - Test, TASK 27-31-00-700-804.
SUBTASK 27-31-11-710-015
(12) Do this task: Elevator Output Torque Tube Buss Linkage - Test, TASK 27-31-00-700-805.
SUBTASK 27-31-11-710-016
(13) Do this task: Elevator Tab Linkage - Test, TASK 27-31-00-700-806.
SUBTASK 27-31-11-710-017
(14) Do this task: Control Column Travel and Centering - Test, TASK 27-31-00-700-808.
SUBTASK 27-31-11-700-003
(15) Do this task: Control Column Power Force - Test, TASK 27-31-00-700-809.
SUBTASK 27-31-11-700-004
(16) Do this task: Elevator Power-Off Flight - Test, TASK 27-31-00-710-803.
NOTE: You may not need to do a power-off flight test, depending on which systems have been
disturbed. To see if you need to do a flight test, check the requirements in the
"General" section at the beginning of the power-off flight test section.
G. Put the Airplane Back to Its Usual Condition
SUBTASK 27-31-11-410-006
(1) Install this access panel:
Number Name/Location
318BR Tailcone Access Door
SUBTASK 27-31-11-410-007
(2) Close this access panel:
Number Name/Location
311BL Stabilizer Trim Access Door
SUBTASK 27-31-11-410-008
(3) For the left elevator, install this access panel:
Number Name/Location
333BB Horizontal Stabilizer, Access Panel, Trailing Edge
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
EFFECTIVITY
GUN ALL 27-31-11
Page 438
Oct 10/2005
D633A101-GUN
BOEING PROPRIETARY - Copyright#Unpublished Work - See title page for details
SUBTASK 27-31-11-410-009
(4) For the right elevator, install these access panels:
Number Name/Location
333BB Horizontal Stabilizer, Access Panel, Trailing Edge
343AB Horizontal Stabilizer, Gap Cover - H. Stab. to Body
SUBTASK 27-31-11-710-020
(5) Do this task: Elevator Power-Off Flight - Test, TASK 27-31-00-710-803.
------------------------- END OF TASK ---------------------------
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
EFFECTIVITY
GUN ALL 27-31-11
Page 439
Oct 10/2005
D633A101-GUN
BOEING PROPRIETARY - Copyright#Unpublished Work - See title page for details
ELEVATOR POWER CONTROL UNIT - REMOVAL/INSTALLATION
1. General
A. This procedure has these tasks:
(1) A removal of an elevator power control unit (PCU)
(2) An installation of an elevator PCU.
B. This procedure is applicable for the left and right elevator PCUs.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-600-700-800-900 AIRCRAFT MAINTENANCE MANUAL飛機維護手冊3(28)