曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

4  FITTING  ID  0.250  0.254  0.264  0.014  X 
BOLT  OD  0.2470  0.2495  0.236  X 
5  ROD  ID  0.3150  0.3180  TBD  TBD  X 
BUSHING  OD  0.3131  0.3136  TBD  X 
6  HINGE-HALF  ID  0.190  0.194  0.204  0.014  X 
PIN  OD  0.187  0.190  0.176  X 
7  BUSHING  ID  0.190  0.192  0.200  0.010  X 
PIN  OD  0.187  0.190  0.180  X 
8  LATCH PAD  2 
SHIMS  OD  1  1 
9  BUSHING  ID  0.190  0.1915  0.200  0.010  X 
SCREW  OD  0.187  0.190  0.180  X 
10  LINK  ID  0.190  0.1915  0.204  X 
SCREW  OD  0.187  0.190  0.176  X 

1 CHANGE THE THICKNESS OF THE SHIMS TO ADJUST THE LATCH (REF 52-48-01/401) REPLACE THE LATCH PAD WHEN IT IS 0.085 INCH THICK

Air Conditioning Access Door Wear Limits
Figure 601 (Sheet 7)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 52-48-01
 ALL  ú ú 01 Page 608 ú Feb 10/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 APU ACCESS DOORS - REMOVAL/INSTALLATION
_______________________________________
 1.  General_______
 A.  This procedure contains two tasks:
 (1)  
The removal of the APU access doors

 (2)  
The installation of the APU access doors.

 B.  
This procedure refers to the APU access door as "the door".

 TASK 52-48-02-004-001
 2.  APU Access Doors Removal (Fig. 401)________________________
 A.  General
 (1)  
There are two alternatives to remove the doors:

 (a)  
Remove the hinge pins from the hinges

 (b)  
Remove the screws that hold the hinges to the fuselage.

 B.  
References

 (1)  
IPC 52-48-02 Fig. 2

 C.  
Access

 (1)  
Location Zone
 317 APU Compartment, LH
 318 APU Compartment, RH

 (2)  
Access Panel
 317A Door - APU Access
 318A Door - APU Access

 D.  
Procedure

 S 014-028
 (1)  
Open the door.

 (a)  
Hold the door with the hold-open rod.

 (2)  
Disconnect the bonding jumpers from the door.

 S 024-030

 (3)
Use one of the two procedures that follow to remove the door:

 (a)  
Remove the hinge pins to remove the door: 1) Remove the retainers that hold the hinge pins on the hinge (Detail A).

 S 034-029
 2)  Hold the door while you do these steps: a) Put the hold-open rods in the door.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 52-48-02
 ALL  ú ú 01 Page 401 ú Feb 10/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

SEE  A  BULKHEAD 
STA 
2742 
BONDING JUMPER 
SEE  E 
BONDING JUMPER  CABLE 
SEE  E  SEE  F 
BULKHEAD 
STA 
2658 
BONDING JUMPER 
HINGE PIN RETAINERS 
(3 LOCATIONS, EACH HINGE) 
SEE  B 
LATCH 
(6 LOCATIONS) 
A  SEE  D 
A  DOOR  BL 0  DOOR 
BONDING JUMPER  (LEFT SIDE)  (RIGHT SIDE) 
HINGE 
SEE  C  ALIGNMENT PIN 
HOLD-OPEN ROD 
(4 LOCATIONS) 
SEAL 
(REF) 
A 
FWD  0.10  INCH (REF)-0.06 +0.02  OUTER SKIN 
0.07  INCH (EXAMPLE)-0.01 +0.03  (REF) 
EXAMPLE ALIGNMENT PIN 
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 艙門 DOORS 4(37)