52-36-02
 ALL  ú ú 01 Page 406 ú Oct 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 CAUTION:_______MAKE SURE THE HEAD OF THE BOLT POINTS UP. THE BOLT CAN CAUSE DAMAGE TO THE CABLE IF YOU INSTALL IT INCORRECTLY.
 2) Install the cable bolt with the head up.
 (c)  Connect the cable that comes from the cable drum to the door.
 S 864-012
 (5)  Lift the door a short distance.
 NOTE: Do this to compress the springs in the spring tube
____
 a small amount.

 S 094-007
 WARNING: MAKE SURE ALL CABLES ARE ATTACHED BEFORE YOU REMOVE THE
_______ SAFETY PIN OR THE CABLE RESTRAINING TOOL. IF YOU REMOVE THE SAFETY PIN OR THE CABLE RESTRAINING TOOL THE CABLE CAN MOVE QUICKLY. IF THE CABLE MOVES QUICKLY IT CAN CAUSE INJURY TO PERSONNEL.
 (6)  
Remove the cable restraining tool or the safety pin, if they are installed.

 S 094-010

 (7)  
If there is a wood block inside the spring tube, remove it as follows.

 (a)  
Remove the two Hi-Loks from the forward end of the spring tube.

 (b)  
Remove the clamp at the center of the spring tube.

 (c)  
Turn the tube until it is sufficiently clear of the floor beam to remove the block.

 (d)  
Remove the cover from the end of the spring tube.

 (e)  
Remove the wood block.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 52-36-02
 ALL  ú ú 01 Page 407 ú Oct 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 (f)
Install the cover on the end of the spring tube.

 (g)  
Turn the spring tube to its correct position.

 (h)  
Install the Hi-Loks at the forward end of the spring tube.

 (i)  
Install the clamp.

 S 864-015
 (8)  
Lower the door.

 S 714-008

 (9)  
Do a test of the balance mechanism.

 (a)  
Disconnect the snubber from the door.

 WARNING: BE CAREFUL WHEN YOU OPERATE THE DOOR WITH THE
_______ SNUBBER DISCONNECTED. IF THE BALANCE MECHANISM IS DEFECTIVE , THE DOOR CAN QUICKLY CLOSE. THIS CAN CAUSE INJURY TO PERSONNEL.
 (b)  
Use a spring scale on the door handle to open and close the door. 1) Make sure the force that is necessary to open the door is

 not more than 25 pounds. 2) Make sure the force that is necessary to close the door is not more than 5 pounds.

 (c)  
Adjust the balance mechanism if it is necessary: 1) Remove the cover from the end of the spring tube. 2) Turn the nut that holds the cable to change the force you

 use to open the door. 3) Install the cover on the end of the spring tube.

 (d)
Connect the snubber to the forward door hinge.

 TASK 52-36-02-204-013
 4. Do a Check of the Bulk Cargo Door Counterbalance
________________________________________________
 NOTE: This is a scheduled maintenance task.
____
 A. References
 (1)  
IPC 52-36-02 Fig. 2

 B.
Access

 (1)  
Location Zone
 146 Bulk Cargo Compartment, RH

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 52-36-02
 ALL  ú ú 03 Page 408 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 (2)  
Access Panel
 823R Door - Bulk Cargo Compartment

 C.
Standard Tools and Equipment

 (1)  
Spring Scale - 50 pound capacity, push type

 D.
Procedure

 S 704-014
 (1)  
Do a test of the balance mechanism.

 (a)  
Disconnect the snubber from the door.

 WARNING: BE CAREFUL WHEN YOU OPERATE THE DOOR WITH THE SNUBBER
_______ DISCONNECTED. IF THE BALANCE MECHANISM IS DEFECTIVE , THE DOOR CAN QUICKLY CLOSE. THIS CAN CAUSE INJURY TO PERSONNEL.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 艙門 DOORS 4(19)