EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-13-02
 ALL  ú ú 01A Page 818 ú Jun 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 (3)  
Cloth padding for inner cylinder surface protection

 (4)  
Nylon sling, 4000-pound capacity - commercially available

 (5)  
Grease gun - commercially available

 C.
Consumable Materials

 (1)  
D00633 Grease - BMS 3-33 (preferred)

 (2)  
D00013 Grease - MIL-G-23827 (optional)

 (3)  
D00589 Lubricant Hydraulic Assembly AFS-682 (Preferred)

 (4)  
D00250 Petrolatum VV-P-236 (Optional)

 (5)  
D00070 Petroleum Base Hydraulic Oil - MIL-H-5606

 (6)
G01395 Compound - Corrosion Inhibition, BMS 3-27, Mastinox 6856K

 D.
References

 (1)  
AMM 07-11-01/201, Jacking Airplane

 (2)  
AMM 07-11-03/201, Jacking Airplane Axles

 (3)  
AMM 09-11-00/201, Towing

 (4)  
AMM 12-15-04/301, Body Landing Gear Shock Strut

 (5)  
AMM 29-11-00/201, Main Hydraulic Supply System

 (6)  
AMM 32-00-30/201 Landing Gear Door Locks

 (7)  
AMM 32-13-02/301, Body Landing Gear Shock Strut

 (8)  
AIPC 32-13-01 Fig. 5

 (9)  
AIPC 32-13-02 Fig. 2

 E.
Prepare for the procedure

 S 498-097
 WARNING: YOU MUST CAREFULLY INSTALL THE GROUND LOCKS IN ALL LANDING
_______ GEAR. AN ACCIDENTAL RETRACTION OF THE LANDING GEAR CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 (1) Install the ground locks in all landing gear (AMM 09-11-00/201).
 S 498-098
 WARNING: YOU MUST CAREFULLY DO THE STEPS IN THE TASK BELOW TO INSTALL
_______ THE DOOR LOCKS ON THE LANDING GEAR DOORS. THE DOORS CAN CLOSE QUICKLY IF YOU DO NOT INSTALL THE DOOR LOCKS CORRECTLY. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (2)  
Do this task: "Installation of the Door Locks on the Wing Landing Gear" (AMM 32-00-30/201).

 S 498-099

 (3)  
Do this task: "Installation of the Door Locks on the Body Landing Gear" (AMM 32-00-30/201).

 S 868-037

 (4)  
Release the pressure on the hydraulic system No. 1
 (AMM 29-11-00/201).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-13-02
 ALL  ú ú 03A Page 819 ú Oct 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 688-038
 (5)  Deflate the shock strut.
 WARNING: DO NOT REMOVE THE VALVE BODY UNLESS YOU DEFLATE THE SHOCK
_______ STRUT FULLY. THE AIR PRESSURE CAN BLOW THE VALVE OUT AND CAUSE INJURY TO PERSONS.
 (a)  Remove the air valve cap and loosen the outer nut no more than two turns.
 NOTE: The hydraulic fluid will have bubbles immediately
____ while you decrease the pressure to the ambient. Deflate the shock strut slowly to prevent the leak of fluid through the air valve.
 (b)  Put a tray below the flow fuse (drain plug).
 S 688-039
 (6)  
When you remove all the pressure on the shock strut, remove the flow fuse and drain the fluid (AMM 32-13-02/301).

 S 498-040

 (7)  
Install the nylon sling to hold the shock strut in the compressed position.

 S 588-041

 (8)  
Lift the airplane until the wheels are clear of the ground (Ref 07-11-01/201).

 S 948-042

 (9)  
Put the axle jacks below each end of the truck beam
 (AMM 07-11-03/201).

 F.
Procedure

 S 038-043
 (1)  
Remove the brake rod bolts from the yoke of the inner cylinder (13) (Fig. 804).

 (a)  
Move the brake rods away from the inner cylinder and attach the rods to the truck.

 NOTE: Lift or lower the end of the truck with the axle jacks.
____ This will release the load on the bolts if it is necessary.
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機(jī)維護(hù)手冊(cè) 起落架 LANDING GEAR 2(154)