31-61-00
ALL ú ú 05 Page 523 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
(b)
Adjust the outer INBD CRT control knob clockwise and counterclockwise. 1) Make sure the inboard IDU becomes brighter when you adjust
the knob clockwise. 2) Make sure the inboard IDU becomes dimmer when you adjust the knob counterclockwise.
(c)
Set the ND mode selector switch on the captain's EFIS control panel to the MAP position.
(d)
Push the WXR switch on the captain's EFIS control panel to the ON position.
(e)
Set the mode selector switch on the control panel for the weather radar to the TEST position.
CAUTION: WHEN THE WEATHER RADAR TRANSMITS RF ENERGY, MAKE SURE
_______ THERE ARE NO LARGE METAL OBJECTS IN AN AREA 300 FEET OR LESS AND IN A 180-DEGREE SECTOR IN FRONT OF THE AIRPLANE. IF LARGE METAL OBJECTS ARE IN THIS AREA WITH THESE CONDITIONS, DAMAGE TO THE WEATHER RADAR RECEIVER CAN OCCUR.
(f)
Adjust the inner INBD CRT control knob clockwise and counterclockwise. 1) Make sure the inboard IDU raster becomes brighter when you
adjust the knob clockwise. 2) Make sure the inboard IDU raster becomes dimmer when you adjust the knob counterclockwise.
(g)
Push the WXR switch on the captain's EFIS control panel to the OFF position.
S 735-834
(2) Do a test of the first officer's lighting control panel:
(a)
Adjust the OUTBD CRT control knob clockwise and counterclockwise. 1) Make sure the outboard IDU becomes brighter when you adjust
the knob clockwise. 2) Make sure the outboard IDU becomes dimmer when you adjust the knob counterclockwise.
(b)
Adjust the outer INBD CRT control knob clockwise and counterclockwise. 1) Make sure the inboard IDU becomes brighter when you adjust
the knob clockwise. 2) Make sure the inboard IDU becomes dimmer when you adjust the knob counterclockwise.
(c)
Set the ND mode selector switch on the first officer's EFIS control panel to the MAP position.
(d)
Push the WXR switch on the captain's EFIS control panel to the ON position.
(e)
Set the mode selector switch on the control panel for the weather radar to the TEST position.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
31-61-00
ALL ú ú 04 Page 524 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
CAUTION: WHEN THE WEATHER RADAR TRANSMITS RF ENERGY, MAKE SURE
_______ THERE ARE NO LARGE METAL OBJECTS IN AN AREA 300 FEET OR LESS AND IN A 180-DEGREE SECTOR IN FRONT OF THE AIRPLANE. IF LARGE METAL OBJECTS ARE IN THIS AREA WITH THESE CONDITIONS, DAMAGE TO THE WEATHER RADAR RECEIVER CAN OCCUR.
(f)
Adjust the inner INBD CRT control knob clockwise and counterclockwise. 1) Make sure the inboard IDU raster becomes brighter when you
adjust the knob clockwise. 2) Make sure the inboard IDU raster becomes dimmer when you adjust the knob counterclockwise.
(g)
Push the WXR switch on the first officer's EFIS control panel to the OFF position.
S 865-835
(3) Remove electrical power if it is not necessary (AMM 24-22-00/201).
N. IDS Local and Remote Light Sensor Test
S 735-836
(1) Do a test of the light sensors:
(a)
Apply black tape to the left remote light sensors on the captain's glare shield.
(b)
Apply black tape to the right remote light sensors on the first officer's glare shield.
(c)
Apply black tape to the local light sensor, found on the bottom of the IDU, on all six IDUs.
(d)
Adjust the INBD CRT and the OUTBD CRT knobs on the captain's lighting control panel to approximately middle range.
(e)
Adjust the INBD CRT and the OUTBD CRT knobs on the first officer's lighting control panel to approximately middle range.
(f)
Adjust the BRT UPR and the BRT LWR knobs on the EICAS control panel/FMC switch to approximately middle range.
(g)
Open these circuit breakers:
1) P7 Overhead circuit breaker panel a) 7F8, UPR EICAS b) 7F12, ND L c) 7F13, PFD L d) 7F14, LWR EICAS e) 7F17, ND R f) 7F18, PFD R 中國航空網 m.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：747-400 AMM 飛機維護手冊 指示/記錄系統 2(140)
