(a)  
On the left power distribution center, P414: 1) 414C5, FUEL OVRD/JTSN PUMP FWD 3 2) 414C2, FUEL OVRD/JTSN PUMP FWD 2 3) 414D2, OVRD/JTSN PUMP CTR L

 (b)  
On the right power distribution center, P415: 1) 415A38, FUEL OVRD/JTSN PUMP AFT 2 2) 415B38, FUEL OVRD/JTSN PUMP AFT 3 3) 415M32, OVRD/JTSN PUMP CTR R

 S 864-028
 CAUTION: MAKE SURE THE CONTROL SELECTOR SWITCH FOR FUEL JETTISON IS IN
_______ THE OFF POSITION. IF YOU DO NOT SET THE CONTROL SELECTOR SWITCH TO THE OFF POSITION, YOU CAN CAUSE THE FUEL TO FLOW TO THE GROUND.
 (5)  Make sure the FUEL JETTISON control selector switch, installed on the P5 pilots' overhead panel, is in the OFF position.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-31-05
 ALL  ú ú 05 Page 407 ú Jun 18/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 864-051
 WARNING: MAKE SURE THE TWO DEFUEL VALVE HANDLES AND THE TWO MANUAL
_______ SHUTOFF VALVE HANDLES ARE IN THE CLOSED POSITION. IF THE DEFUEL VALVES OR MANUAL SHUTOFF VALVES ARE OPEN, FUEL CAN FLOW FROM THE FUEL-FEED MANIFOLD INTO THE REFUEL/JETTISON MANIFOLD. IF A JETTISON NOZZLE VALVE IS OPEN, FUEL CAN FLOW FROM THE WING TIPS AT THE JETTISON NOZZLES. A FUEL LEAK CAN CAUSE INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT.
 (6)  Make sure the handles for the manual defuel valves and manual shutoff valves (found at the left and right pressure refuel stations) are in the closed position.
 S 864-044
 WARNING: MAKE SURE THERE IS NOT PRESSURE IN THE REFUEL/JETTISON
_______ MANIFOLD. IF THERE IS PRESSURE IN THE REFUEL/JETTISON MANIFOLD, A FUEL LEAKAGE CAN OCCUR. FUEL CAN FLOW FROM THE JETTISON NOZZLES WHICH CAN CAUSE A DANGEROUS CONDITION FOR EQUIPMENT AND PERSONS.
 (7)  
Wait a minimum of 1.5 hours after a refuel, defuel or fuel transfer operation to make sure the refuel/jettison manifold is not pressurized.

 S 864-045

 (8)  
If it is necessary to do maintenance before the 1.5 hours time limit, do these steps to remove the pressure from the refuel/jettison manifold.

 WARNING: REFER TO AMM 27-81-00/201 FOR LOCK INSTALLATION PROCEDURE.
_______ FLAPS WILL RETRACT IN 7 SECONDS. INSTALL LOCKS TO PREVENT INJURY FROM INADVERTENT OPERATION OF FLAPS.
 (a)  
Install the locks on all the extended leading edge flaps (AMM 27-81-00/201).

 (b)  
Open the access door, 521CB, to get to the refuel control panel, P42.

 (c)  
Make sure the floodlights come on and there is power.

 (d)  
Make sure the fuel quantity gages show a fuel quantity.

 (e)  
Make sure the No. 2 and No. 3 main tanks are not full (at VTO).

 (f)  
Make sure the OVERFILL red light is not on.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-31-05
 ALL  ú ú 02 Page 408 ú Jun 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 (g)  Put the refuel valve switches, MAIN 2 and MAIN 3, to the OPEN
 position.
 NOTE:____ This will remove the pressure from the refuel/jettison
 manifold.  The blue indication lights for the refuel
 valves in the No. 2 and No. 3 main tanks will come on if
 the refuel/jettison manifold pressure is more than
 6 psig and the refuel valve is operational.
 1)  If a blue indication light did not come on, it is possible
 that the refuel valve did not operate electrically.
 a)  Use the manual method to open the applicable refuel
 valve(s) (AMM 12-11-01/301).
 b)  Wait for 5 minutes.
 c)  Close the refuel valve(s) that were opened manually
 (AMM 12-11-01/301).
 (h)  After the blue indication lights for the refuel valves go off,
 wait for 5 minutes.
 (i)  Put the refuel valve switches, MAIN 2 and MAIN 3, to the CLOSED
 position.

 S 014-032
 (9)
Remove the access door, 556AB or 656AB, for the wingtip dry bay.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 燃油 FUEL 4(52)