(g)  
Attach the housing assembly to the aircraft structure using 4 screws and washers.

 S 424-017
 (5)  To install the continuous side guide assembly on the left side of the cargo compartment, opposite the cargo doorway between STA 560 and STA 660, do the following steps in sequence:
 (a)  
Put a rail and nut assembly on the rectangular nose of the installed side guide assembly.

 (b)  
Put the rectangular nose of the next side guide unit on the rail and nut assembly.

 (c)  
Repeat these steps to install the continuous side guides up to STA 660.

 (d)  
Install the profile supports and clamps together with the plates on the rail and nut assembly.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-54-03
 ALL  ú ú 02 Page 408 ú Oct 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 424-018
 (6)  To install the continuous side guides between STA 660 and STA 960, do the following steps in sequence:
 (a)  
Put a rail and nut assembly on the rectangular nose of the previously installed unit.

 (b)  
Put the rectangular nose of the next side guide assembly on the rail and nut assembly.

 (c)  
Attach the side guide assembly to the aircraft structure using the bolts washers and nuts removed at this location.

 (d)  
Repeat these steps until the side guides are installed up to STA 960.

 (e)  
FOR AREA OF ARTICULATION BETWEEN STA 760 AND 780 ONLY; Install the clamps without plates on the rail and nut assembly. Use only the removed the screws.

 (f)  
FOR ALL OTHER AREAS OF ARTICULATION; Install the profile supports and clamps together with the plates on the rail and nut assembly.

 S 424-019
 (7)  To install the end guides at STA 960:
 (a)  
Put a rail and nut assembly on the rectangular nose of the previously installed unit.

 (b)  
Put the rectangular nose of the end guide assembly on the rail and nut assembly.

 (c)  
Install the end guide assembly to the aircraft structure using the bolts, washers and nuts removed at this location.

 E. Put the Airplane Back to Its Usual Condition
 S 844-020
 (1)  
Push the CAUTION switch-light on the cargo control panel until it stops flashing.

 S 094-021

 (2)  
Remove the safety barrier (3PRE65B00040) from the opening of the cargo compartment if it is not necessary.

 (3)  
Close the cargo compartment door (AMM 52-34-00/001).

 S 864-023

 (4)  
Remove the electrical ground power if it is not necessary
 (AMM 24-22-00/201).

 S 414-022
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-54-03
 ALL  ú ú 02 Page 409 ú Oct 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 TASK 25-54-03-004-024
 4.  Aft Cargo Compartment Continuous Side Guide Removal (Fig. 401)___________________________________________________
 A. Special Tools and Equipment
 (1)  3PRE65B00040, Lower Cargo Door Opening Safety Barrier
 B. References
 (1)  
AMM 24-22-00/201, Manual Control

 (2)  
AMM 52-34-00/001, Forward/Aft Cargo Doors

 (3)  
AIPC 25-53-16

 C. Access
 (1)  Location Zone
 100 Lower Half of Fuselage

 D. Prepare for the Removal
 S 864-025
 (1)  
Supply electrical ground power (AMM 24-22-00/201).

 S 014-026

 (2)  
Open the cargo compartment door (AMM 52-34-00/001).

 S 494-027
 WARNING: BE CAREFUL WHEN YOU ARE NEAR THE OPENING OF THE CARGO
_______ COMPARTMENT DOOR. INSTALL A SAFETY BARRIER (3PRE65B00040) ACROSS THE OPENING OF THE DOOR UNLESS AN ACCESS STAND IS AT THE DOOR. INJURY TO PERSONS CAN OCCUR IF THEY FALL THROUGH THE OPENING OF THE DOOR.
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 EQUIPMENT/FURNISHINGS 2(27)