25-53-22
 ALL  ú ú 02 Page 401 ú Oct 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

FORWARD CARGO COMPARTMENT  AFT CARGO COMPARTMENT 
SEE  A  SEE  B 
STA 480  CSEE ADEC BOX  FORWARD CARGO COMPARTMENT DOORWAY  SEE C ADEC BOX  COMPARTMENT DOORWAY AFT CARGO  1975 STA 

FWD  FWD
FORWARD CARGO COMPARTMENT AFT CARGO COMPARTMENT AB
TRANSPORT ROLLER
ROLLER SCREW
TRAY (4 LOCATIONS)
WASHER
(4 LOCATIONS)
ELECTRICAL CONNECTORS (2 LOCATIONS)
ADEC BOX
ADEC BOX (EXAMPLE)
C
ADEC Box Installation Figure 401
L52828
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-53-22
 ALL  ú ú 02 Page 402 ú Oct 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 S 844-027
 (4)  
Push the CAUTION switch-light on the cargo control panel until it starts to flash.

 S 844-028

 (5)  
Make sure the POWER DRIVE SYSTEM switch on the cargo control panel is in the OFF position.

 E. Remove the ADEC Box
 S 014-020
 (1)  
If installed, remove the two transport rollers above the ADEC Box to allow easy access to the ADEC Box attaching parts. If necessary, refer to AMM 25-53-24/401, Transport Roller Installation.

 S 024-022

 (2)  
Remove the four screws which attach the ADEC Box to the roller tray. Save the screws so that you can re-install the unit later.

 S 024-007

 (3)  
Disconnect the electrical connectors from the ADEC Box.

 TASK 25-53-22-404-008
 3. ADEC Box Installation (Fig. 401)
_____________________
 A. Special Tools and Equipment
 (1)  3PRE65B00040, Lower Cargo Door Opening Safety Barrier
 B. References
 (1)  
AMM 24-22-00/201, Manual Control

 (2)  
AMM 52-34-00/001, Forward/Aft Cargo Doors

 (3)  
AMM 25-53-23/401, Transport Roller Installation

 (4)  
AIPC 25-53-16

 C. Access
 (1)  Location Zone
 100 Lower Half of Fuselage

 D. Procedure
 NOTE: The ADEC Boxes for the forward and aft cargo compartments have
____ different part numbers and are not interchangeable.
 S 424-009
 (1)  For the forward cargo compartment, connect the electrical connectors to the receptacles on the ADEC Box as follows:
 (a) Connect electrical connector DM9399A to receptacle A.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-53-22
 ALL  ú ú 02 Page 403 ú Oct 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 (b)  Connect electrical connector DM9399B to receptacle B.
 S 424-019
 (2)  For the aft cargo compartment, connect the electrical connectors to the receptacles on the ADEC Box as follows:
 (a)  
Connect electrical connector Dm9499A to receptacle A.

 (b)  
Connect electrical connector Dm9499B to receptacle B.

 S 424-023
 (3)  
Install the ADEC Box to the roller tray using four screws.

 S 424-024

 (4)  
If removed, reinstall the two transport rollers at the ADEC Box position. If necessary, refer to AMM 25-53-24/401, Transport Roller Installation.

 S 714-025

 (5)  
Do an operational test of the cargo loading system
 (AMM 25-53-00/501).

 E. Put the Airplane Back to Its Usual Condition
 S 414-029
 (1)  
Remove the safety barrier (3PRE65B00040) from the opening of the cargo compartment if it is not necessary.

 (2)  
Close the cargo compartment door (AMM 52-34-00/001).

 S 864-018

 (3)  
Remove the electrical ground power if it is not necessary
 (AMM 24-22-00/201).
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 EQUIPMENT/FURNISHINGS 2(11)