SEE C
CHUTE TORQUE
BASE ASSEMBLY BAR
(PLATFORM) SWIVEL
FITTING
FLOOR INBD FWDTRACKS
SLIDE IN OPERATION-READY POSITION
A
Floor-Mounted Escape Slide - Component Location Figure 102 (Sheet 1)
C08319
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-68-00
 ALL  ú CONFIG 2 ú 02 Page 102 ú Feb 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

747-400
FAULT ISOLATION/MAINT MANUAL

CHUTE CHUTE EXTENSION PANEL AND
EXTENSION PACKBOARD LOCKING PLATE
PANEL

MANUAL INFLATION HANDLE
ESCAPE
SLIDE
PACK

FLOOR
ENTRY

TRACKS
DOORWAY

CHUTE INBDFWD
FLOOR PACKBOARD
TRACK FLOOR
RELEASE RAMP
SHROUD PACKBOARD
(PAWL LOCKS)
BASE ASSEMBLY MANUAL RELEASE
(PLATEFORM) ASSIST HANDLE HANDLE BOTTLE FIRING
SLIDE IN OPERATION-READY POSITION
LANYARD
PIVOT SUPPORT
RETAINER
B SPRING  REGULATOR
MANUAL BOTTLE
INFLATION
HANDLE OUTBOARD HINGED SECTIONCABLE ASSEMBLIES
GAS SUPPLY HOSE (2 LOCATIONS) STOWAGE CONTAINER RETAINER PIN
STORED FWD
(2 LOCATIONS) GAS
INBOARD
BOTTLE
HINGED SECTION
INBD
CRADLE
SUPPORT
ASSEMBLY
BASE ASSEMBLY (PLATFORM)
STORED GAS BOTTLE INSTALLATION
C
Floor-Mounted Escape Slide - Component Location
Figure 102 (Sheet 2)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-68-00
 ALL  ú CONFIG 2 ú 02 Page 103 ú Feb 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
C08320
A

747-400
FAULT ISOLATION/MAINT MANUAL

HOSE GAS SUPPLY ESCAPE SLIDE  CHUTE  STORED GAS BOTTLE ENTRY DOORWAY 
SLIDE ESCAPE GIRT 
FITTING SWIVEL 
PLATE RAMP 
SHROUD  RAMP FLOOR 
FWD  INBD 
ESCAPE SLIDE DEPLOYED 

Floor-Mounted Escape Slide - Component Location
Figure 102 (Sheet 3)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-68-00
 ALL  ú CONFIG 2 ú 02 Page 104 ú Feb 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
C08321
A
747-400 MAINTENANCE MANUAL
 FLOOR-MOUNTED ESCAPE SLIDE - MAINTENANCE PRACTICES (RESTORATION)
________________________________________________________________
 1.  General_______
 A.  This procedure contains a task that restores the floor-mounted escape slide after it has deployed.
 TASK 25-68-00-842-001-002
 2.  Restore the Floor-Mounted Escape Slide______________________________________
 A.  Special Tools and Equipment
 (1)  Escape slide deflation tool
 NOTE:  You will use this tool to deflate the escape slide. The tool is inserted in the turbine pumps to open the slide check valves. The tool can be made from wood or plastic that is
 0.50 inch in diameter, with a "tee" handle to keep the tool from falling into the slide. The end of the tool must be covered with rubber to prevent damage to the slide.
 (2)  
Rope (or cord) - 1/4 or 3/8 inch diameter by 50 feet long

 (3)  
Right side entry door opening safety barrier - 6PRE65B00040

 B.  Access
 (1)  
Location Zone
 224 Fwd Upper Deck, RH

 (2)  
Access Panel
 849R Upper Deck Emergency Door, RH

 C.  Procedure
 S 982-002-002
 (1)  
Deflate the slide as follows (Fig. 201):

 (a)  
Open the fitting at the bottom of the slide.

 (b)  
Continue to deflate the slide until it is soft but keeps its shape (approximately 1 psi).

 (2)  
Disconnect the gas supply hose.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 EQUIPMENT/FURNISHINGS 2(161)