(3)  
If you do not have a replacement (pretested) engine, then you must do the procedures in Test No. 10 (Replacement Engine Test (Untested)).

 B.  
References

 (1)  
AMM 24-11-11/501, Generator Constant Speed Drive

 (2)  
AMM 30-21-00/501, Inlet Cowl Anti-Icing System

 (3)  
AMM 31-24-00/501, Flight Recorder System

 (4)  
AMM 36-11-05/501, Engine Bleed Air Distribution System

 (5)  
AMM 71-00-00/201, Power Plant

 (6)  
AMM 71-00-54/101, Power Plant (Engine Indicating)

 (7)  
AMM 78-31-00/201, Fan Thrust Reverser System

 (8)  
AMM 79-00-00/601, Oil

 C.  
Access

 (1)  
Location Zones
 506 Engine No. 1
 606 Engine No. 2

 (2)  
Access Panels
 5737L/5837R Fan Cowl Assy
 5746L/5846R Fan Cowl Assy
 5738L/5838R Thrust Reverser Cowl Assy
 5739L/5839R Thrust Reverser Cowl Assy

 D.  
Procedure

 S 725-018-C00
 (1)  
Do the Replacement Engine Test

 (a)
Open the thrust reverser, if it is not open (AMM 78-31-00/201).

 (b)
Do the pneumatic leak test (Test No. 1), with these steps:

 CAUTION: DO NOT OPERATE THE COWL TAI FOR MORE THAN 30 SECONDS.
_______ DAMAGE TO THE COWL CAN OCCUR.
 1)  On the pilots' forward overhead panel, P5, put the applicable ENG ANTI-ICE switch in the ON position for 25 to 30 seconds.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
 71-00-00
 ALL  ú ú C09 Page 570 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
TEST NO. 9 - REPLACEMENT ENGINE TEST (PRETESTED)
________________________________________________
 2)  Examine the TAI duct for a leak at the couplings.
 NOTE: You cannot have a jet of air at the couplings.
____ You can have a small leakage around the coupling.
 3)  Put the ENG ANTI-ICE switch in the OFF position.
 (c)  
Close the thrust reverser (AMM 78-31-00/201).

 (d)  
Do the MEC trim check (Test No. 6).

 NOTE: It is not necessary to do the static rig check (in
____ test No. 6), if the engine completed this check before. But you must always do the engine run checks of the MEC (in test No. 6).
 It is not necessary to do the Test No. 8 - accel/decel check in Test No. 6.
 (e)  
After the initial trim check, examine the magnetic chip detectors in the lube unit for contamination (AMM 79-00-00/601).

 (f)  
See if there is a fault display on the AVM signal conditioner (found on the E1-2 electronic shelf in the main E/E rack). 1) Correct the faults, if it is necessary (AMM 71-00-54/101).

 (g)  
Do the operational test for the TAI system on the inlet cowl (AMM 30-21-00/501).

 CAUTION: IF THE SYSTEM TEST OF THE BLEED AIR CONTROL IS
_______ UNSATISFACTORY, EXAMINE THE LINES BETWEEN THE STRUT AND THE BLEED AIR REGULATOR. IF THE LINES ARE NOT CORRECT, THE SYSTEM WILL HAVE A LOWER PRESSURE IN FLIGHT.
 (h)  
Do the system test of the bleed air control (test the bleed air control system with the engine running) (AMM 36-11-05/501).

 (i)  
Do the CSD disconnect test (AMM 24-11-11/501).

 (j)  
Before the engine shutdown, do the flight recorder check.

 CAUTION:_______DO THE FLIGHT RECORDER TEST IN A MINIMUM TIME. THIS WILL PREVENT THE LOSS OF THE DATA IN THE RECORDS.
 1)  Remove the DO-NOT-CLOSE tags and close these circuit
 breakers on the circuit breaker panel, P18.
 a) FLIGHT RECORDER AC
 b) FLIGHT RECORDER DC

 2) Make sure that the flight recorder system operates.
 a) Make sure that the FLIGHT RECORDER light on the
 overhead panel, P5, goes out.

 (k)  Do the engine shutdown (normal) operation (AMM 71-00-00/201). 1) Make sure that the FLIGHT RECORDER light comes on.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 動力裝置 POWER PLANT 1(77)