33-45-11
 POSITION LIGHTS  ú ú 05 Page 203 ú Jul 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 (b)  At the overhead panel, P5, set the switch to the off position and attach the DO-NOT-OPERATE tag.
 S 012-014
 (2) Remove the screws to remove the access panel below the wingtip.
 S 032-034
 WARNING: DO NOT TOUCH THE LIGHT WITH YOUR BARE HANDS UNTIL THE LIGHT IS
_______ OFF FOR A MINIMUM OF FIVE MINUTES. DURING THIS TIME, YOU CAN RECEIVE AN INJURY IF YOU TOUCH THE LIGHT. THE LIGHT CAN BURN YOUR SKIN OR GIVE YOU AN ELECTRICAL SHOCK.
 (3)  
Disconnect the electrical connector from the light.

 S 032-028

 (4)  
Remove the mounting bolts.

 S 032-029

 (5)  
To help in the removal of the light, turn or move the mounting bracket on one side of the light.

 (a)  
Turn the mounting bracket (Recommended Procedure). 1) Remove three of the mounting screws and loosen the fourth

 mounting screw. 2) Turn the mounting bracket.

 (b)  
Remove the mounting bracket (Alternative Procedure). 1) Remove the four mounting screws. 2) Remove the mounting bracket.

 S 022-030
 (6)  Pull the light clear of the airplane.
 TASK 33-45-11-402-017
 4.  Wingtip Strobe Position Light Installation (Fig. 201)__________________________________________
 A. References
 (1)  
AMM 24-22-00/201, Manual Control

 (2)  
SSM 33-40-03

 (3)  
WDM 33-43-01

 B. Access
 (1)  Location Zone
 301 Left Wing Tip
 401 Right Wing Tip

 C. Light Installation
 S 962-018
 (1)  If it is necessary to replace the lamp, do the task, Wingtip Position Strobe Light Lamp Replacement.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH STROBE ú

 33-45-11
 POSITION LIGHTS  ú ú 02 Page 204 ú Nov 15/93
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 432-031
 (2)  
Install the mounting bracket with the mounting screws.

 S 422-019

 (3)  
Install the light.

 (a)  
Put the light back in the wingtip.

 (b)  
Install the mounting bolts.

 (c)  
Connect the electrical connector to the light.

 S 412-021
 (4)  Install the access panel with the screws.
 D. Light Test
 S 862-035
 (1)  
Supply electrical power (AMM 24-22-00/201).

 S 862-036

 (2)  
Remove each DO-NOT-CLOSE or DO-NOT-OPERATE tag.

 (a)  Close each circuit breaker that was opened when the light was removed.
 S 862-038
 (3) Set the switch for the strobe position lights to the on position.
 CAUTION: DO NOT LET THE STROBE POSITION LIGHTS FLASH DIRECTLY IN
_______ YOUR EYES. THE INTENSITY OF THE LIGHT CAN CAUSE YOU TO NOT SEE TEMPORARILY.
 (a)  Make sure that the light flashes at the rate of 60 +/- 10 times per minute.
 S 862-039
 (4)  
Set the switch to the off position.

 (5)
Remove electrical power if it is not necessary (AMM 24-22-00/201).

 S 862-024
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH STROBE ú

 33-45-11
 POSITION LIGHTS  ú ú 02 Page 205 ú Nov 15/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 TAIL STROBE POSITION LIGHT - MAINTENANCE PRACTICES
__________________________________________________
 1.  General_______
 A.  This procedure has this task for a tail strobe position light (referred to as the light):
 (1)  Tail Strobe Position Light - Lamp Replacement
 TASK 33-45-21-962-001
 2.  Tail Strobe Position Light - Lamp Replacement (Fig. 201)_____________________________________________
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 燈 LIGHTS(88)