33-42-41
 ALL  ú ú 02 Page 201 ú Mar 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL

INBOARD LANDING LIGHT (REF)
RETAINER
LAMP
FRAME

A-A

Runway Turnoff Lights
Figure 201

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 33-42-41
 ALL  ú ú 02 Page 202 ú Jul 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 022-003
 (2)  Remove the lamp.
 (a)  Remove the retainer screws.
 NOTE: Make sure you do not turn the adjustment screws.
____
 (b)  
Remove the retainer.

 (c)  
Remove the lamp from the frame.

 (d)  
Disconnect the electrical wires from the terminals of the lamp.

 (e)  
Remove the gasket from the frame.

 S 422-004
 (3)  Install the new lamp.
 (a)  
Clean the light assembly with a clean dry cloth.

 (b)  
Wind a new gasket around the lamp using the BMS1-68F tape.

 (c)  
Clean the terminals of the lamp and the ends of the electrical wires to remove all dirt and corrosion.

 (d)  
Connect the electrical wires to the terminals of the lamp.

 NOTE: Tighten the screws until the lockwashers are fully
____
 compressed.

 WARNING: MAKE SURE YOU SEAL THE TERMINAL TO PREVENT AN EXPLOSION OF
_______ THE FUEL FUMES. AN EXPLOSION CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 (e)  
Do this task: "Seal the Open Terminals" (AMM 20-10-47/201).

 (f)  
Put the lamp in the frame.

 (g)  
Align the lug on the lamp with the slot in the frame.

 CAUTION: HOLD THE LAMP IN THE CORRECT POSITION WHILE YOU INSTALL
_______ THE RETAINER. IF THE LAMP IS IN THE INCORRECT POSITION, THE INSTALLATION OF THE RETAINER CAN BREAK THE LAMP.
 (h)  Hold the lamp and install the retainer with the screws.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 33-42-41
 ALL  ú ú 01 Page 203 ú Mar 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 722-005
 (4)  Do a test of the runway turnoff lights.
 (a)  
Supply electrical power (Ref 24-22-00/201).

 (b)  
Remove the DO-NOT-CLOSE tags and close these circuit breakers:

 1)  P18-3 Load Control Center - Left a) RIGHT RUNWAY TURNOFF b) LEFT RUNWAY TURNOFF
 CAUTION: DO NOT MAKE THE LIGHTS COME ON FOR MORE THAN FIVE MINUTES.
_______ AFTER YOU MAKE THE LIGHTS COME ON, MAKE THE LIGHTS GO OFF FOR AN EQUAL TIME. BECAUSE OF THE HEAT, THE CONTINUED OPERATION OF THE LIGHTS CAN DECREASE THE LIFE OF THE LAMPS.
 (c)  Set the RUNWAY TURNOFF switches of the overhead panel, P5, to ON. 1) Make sure the lights come on. 2) Make sure the lighting, on each side of the airplane, falls
 on symmetrical areas of the ground.
 NOTE: If the lighting is not symmetrical, then adjust the
____ lights (Ref 33-42-31/501).
 (d) Set the RUNWAY TURNOFF switches of the P5 panel to OFF.
 E.  Put the airplane back to its usual condition.
 S 862-009
 WARNING: YOU MUST CAREFULLY DO THE STEPS IN THE TASK BELOW TO INSTALL
_______ THE LENS. THE SEAL OF THE LENS MUST STOP ALL FUEL FUMES. IF THERE ARE LEAKS IN THE SEAL, FUEL FUMES CAN COLLECT NEAR THE LIGHT AND CAUSE AN EXPLOSION. AN EXPLOSION CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 (1)  Install the lens of the inboard landing and runway turnoff light (Ref 33-42-21/401).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 33-42-41
 ALL  ú ú 01 Page 204 ú Mar 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機(jī)維護(hù)手冊 燈 LIGHTS(68)