C. Lens Removal
 S 864-022
 (1)  Do one of these steps to remove electrical power from the lower anticollision light:
 (a)  
At the overhead panel, P5, set the switch to the off position and attach the DO-NOT-OPERATE tag.

 (b)  
Open each applicable circuit breaker and attach the DO-NOT-CLOSE tag: 1) On the load control center panel, P18.

 S 024-024
 (2)  Remove the lens.
 (a)  
Loosen the retaining nut.

 (b)  
Carefully remove the retainer band and the lens.

 (c)  
Remove each gasket.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 33-44-24
 ALL  ú ú 01 Page 404 ú Mar 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL

LOWER ANTICOLLISION LIGHT (EXAMPLE)
A

Lower Anticollision Light - Lens Installation
Figure 402

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 33-44-24
 ALL  ú ú 01 Page 405 ú Jul 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
E38549
A
737-300/400/500MAINTENANCE MANUAL
 TASK 33-44-24-404-025
 5. Lower Anticollision Light - Lens Installation (Fig. 402)
_____________________________________________
 A. References
 (1)  
AMM 24-22-00/201, Manual Control

 (2)  
SSM 33-40-02

 (3)  
WDM 33-44-01

 B. Access
 (1)  Location Zone
 200 Lower Half of Fuselage

 C. Light Installation
 S 144-026
 (1)  
Clean the inner and outer side of the lens with a clean, soft, dry cloth.

 S 424-027

 (2)  
Install the lens.

 (a)  
Install each gasket.

 (b)  
Carefully put the lens and retainer in position.

 (c)  
Tighten the retaining nut.

 D. Light Test
 S 864-039
 (1)  
Supply electrical power (AMM 24-22-00/201).

 S 864-040

 (2)  
Remove each DO-NOT-OPERATE or DO-NOT-CLOSE tag.

 (a)  Close each circuit breaker that was opened.
 S 714-041
 (3)  At the overhead panel, P5, set the switch for the lower anticollision light to the on position.
 WARNING: DO NOT LET THE STROBE LIGHT FLASH DIRECTLY IN YOUR EYES.
_______ THE INTENSITY OF THE LIGHT CAN CAUSE YOU TO NOT SEE TEMPORARILY.
 (a) Make sure the light comes on and flashes correctly.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 33-44-24
 ALL  ú ú 01 Page 406 ú Mar 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 (4)  S 864-042Set the switch to the off position.
 (5)  S 864-032Remove electrical power if it is not necessary (AMM 24-22-00/201)

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 33-44-24
 ALL  ú ú 01 Page 407 ú Mar 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
 1.

2.

3.

A
737-300/400/500MAINTENANCE MANUAL
 STROBE POSITION LIGHTS - DESCRIPTION AND OPERATION
__________________________________________________
General
_______
 A.  A strobe position light is installed on each wingtip and on the fuselage tail cone.
 B.  These white lights flash approximately 60 times each minute to show the location of the airplane.
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 燈 LIGHTS(85)