曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 S 725-061
 (2)  If there are emergency lights that did not come on for 10 or more minutes, then do one more test of the emergency lights.
 (a)  Set the pilot's emergency lights switch to the on position.
 1)  Make sure each emergency light comes on for a minimum time of 10 minutes. a) Let each emergency light go off automatically.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 33-51-02
 ALL  ú ú 03 Page 506 ú Nov 15/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 (b) (c)  Set the pilot's emergency lights switch to the off position.Replace the battery pack in each power supply that operated its emergency lights for less than 10 minutes (AMM 33-51-51/201).
 (d)  Supply electrical power for 16 hours to fully charge the batteries (AMM 24-22-00/201).
 NOTE:____ This will prepare the emergency lights for a flight of the airplane.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 33-51-02
 ALL  ú ú 02 Page 507 ú Nov 15/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 ELECTRICALLY ILLUMINATED EXIT SIGNS - MAINTENANCE PRACTICES
___________________________________________________________
 1.  General_______
 A.  This procedure contains these tasks for an electrically illuminated exit sign (referred to as an exit sign):
 (1)  
Exit Sign - Lamp Replacement

 (2)  
Exit Sign - Lamp Assembly Removal

 (3)  
Exit Sign - Lamp Assembly Installation

 TASK 33-51-11-962-002
 2.  Exit Sign - Lamp Replacement (Fig. 201)____________________________
 A.  References
 (1)  
AMM 33-51-51/201, Power Supply

 (2)  
SSM 33-15-00

 (3)  
WDM 33-00-01, Lamp Usage Chart

 (4)  
WDM 33-51-11 thru 33-51-31

 B.  Access
 (1)  Location Zone
 100 Upper Half of Fuselage

 C.  Lamp Replacement
 S 032-030
 (1)  Remove the lens.
 (a)  
For a lens with release holes, push a wire in each release hole and remove the lens.

 (b)  
For a lens with release buttons, push each release button with your fingers and remove the lens.

 (c)  
For a lens without release holes or buttons, pull off the lens.

 S 962-031
 (2)  Carefully replace the lamp.
 D.  Lamp Test
 S 712-005
 (1)  At the overhead panel, P5, or the attendant's panel, set the emergency lights switch to the on position.
 NOTE: Keep a record of the time that the emergency lights are on.
____
 (a)  In the least possible time, make sure the new lamp comes on correctly.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 33-51-11
 ALL  ú ú 01 Page 201 ú Mar 15/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL 
WIRES ELECTRICAL  LENS  ELECTRICAL WIRES 
LENS 

LAMP  SCREW AND 
(EXAMPLE)  WASHER 
(2 LOCATIONS) 
SCREW AND WASHER  DOOR  HOUSING  HOUSING  RELEASE HOLE (2 LOCATIONS) 
(2 LOCATIONS)  HOUSING  SCREW AND  (EXAMPLE) LAMP 
EXIT SIGN (EXAMPLE)  (4 LOCATIONS) SPACER  EXIT SIGN WITH RELEASE HOLES (EXAMPLE) 

RELEASE BUTTON
LAMP (2 LOCATIONS) (EXAMPLE)
LENS
COVER LENSRELEASE HOLE
EXIT SIGN WITH RELEASE BUTTONS LAMP (EXAMPLE) (EXAMPLE)
RELEASE HOLE (2 LOCATIONS)
SCREW SCREW
(6 LOCATIONS) (4 LOCATIONS)
SCREW LAMP (6 LOCATIONS)RELEASE (EXAMPLE)
HOLE SCREW (4 LOCATIONS) LENS
ELECTRICAL HOUSINGCONNECTOR
SIDEWALL LIGHT (REF) SIDEWALL LIGHT (REF)
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 燈 LIGHTS(100)