WARNING: MAKE SURE YOU SEAL THE TERMINALS TO PREVENT AN EXPLOSION
_______ OF THE FUEL FUMES. AN EXPLOSION CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 (g)
Do this task: "Seal the Open Terminals" (AMM 20-10-47/201).

 (h)  
Put the lamp in the frame. 1) For a halogen lamp, align the filament of the lamp horizontally.

 2)  For an incandescent lamp, make sure the filament shroud of the lamp is nearest to the fuselage.
 CAUTION: HOLD THE LAMP IN THE CORRECT POSITION WHILE YOU INSTALL
_______ THE RETAINER. IF THE LAMP IS IN THE INCORRECT POSITION, THE INSTALLATION OF THE RETAINER CAN BREAK THE LAMP.
 (i)  Hold the lamp and install the retainer with the screws.
 S 722-004
 (4)  Do a test of the inboard landing lights.
 (a)  
Supply electrical power (Ref 24-22-00/201).

 (b)  
Remove the DO-NOT-CLOSE tags and close these circuit breakers:

 1)  P18-3 Load Control Center - Left
 a) RIGHT INBOARD LANDING LIGHTS
 b) LEFT INBOARD LANDING LIGHTS

 CAUTION: DO NOT MAKE THE LIGHTS COME ON FOR MORE THAN FIVE MINUTES.
_______ AFTER YOU MAKE THE LIGHTS COME ON, MAKE THE LIGHTS GO OFF FOR AN EQUAL TIME. BECAUSE OF THE HEAT, THE CONTINUED OPERATION OF THE LIGHTS CAN DECREASE THE LIFE OF THE LAMPS.
 (c)  Set the LANDING INBOARD L and LANDING INBOARD R switches of the overhead panel, P5, to ON. 1) Make sure the lights come on.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 33-42-31
 ALL  ú ú 01 Page 204 ú Mar 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 2)  Make sure the lighting, on each side of the airplane, falls on symmetrical areas of the ground.
 NOTE: If the lighting is not symmetrical, then adjust the
____ lights (Ref 33-42-31/501).
 (d) Set the LANDING INBOARD L and R switches of P5 to OFF.
 E.  Put the airplane back to its usual condition.
 S 862-009
 WARNING: YOU MUST CAREFULLY DO THE STEPS IN THE TASK BELOW TO INSTALL
_______ THE LENS. THE SEAL OF THE LENS MUST STOP ALL FUEL FUMES. IF THERE ARE LEAKS IN THE SEAL, FUEL FUMES CAN COLLECT NEAR THE LIGHTS AND CAUSE AN EXPLOSION. AN EXPLOSION CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 (1)  Install the lens of the inboard landing and runway turnoff light (Ref 33-42-21/401).
 S 862-010
 WARNING: YOU MUST CAREFULLY DO THE STEPS IN THE TASK BELOW TO REMOVE THE
_______ LEADING EDGE FLAP AND SLAT LOCKS CORRECTLY. THE LEADING EDGE FLAPS AND SLATS CAN MOVE QUICKLY IF YOU DO NOT REMOVE THE LOCKS CORRECTLY. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (2)  
Do this task: "Leading Edge Flap and Slat Locks Removal" (Ref 27-81-00/201).

 S 862-007

 (3)  
Remove the electrical power if it is not necessary
 (Ref 24-22-00/201).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 33-42-31
 ALL  ú ú 01 Page 205 ú Mar 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 INBOARD LANDING LIGHTS - ADJUSTMENT/TEST
________________________________________
 1.  General_______
 A.  This procedure has these tasks:
 (1)  
Inboard Landing Light - Adjustment with a Light Aligner

 (2)  
Inboard Landing Light - Adjustment with a Target

 B.  Each inboard landing light is adjacent to a runway turnoff light. The two lights are behind one lens.
 C.  The inboard landing lights are in a fuel vapor area. Each lamp, electrical connection, and lens has a seal to stop all fuel fumes and water.
 D.  This procedure contains a recommended adjustment procedure and an alternative adjustment procedure. Use one of the two adjustment procedures.
 E.  The ground must be level below and in front of the airplane.
 TASK 33-42-31-825-002
 2.  Inboard Landing Light - Adjustment with a Light Aligner (Fig. 501 and 502)_______________________________________________________
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 燈 LIGHTS(64)