EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
33-44-00
ALL ú ú 01 Page 101 ú Oct 25/85
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
ANTICOLLISION LIGHTS - ADJUSTMENT/TEST
______________________________________
TASK 33-44-00-715-002
1. Anticollision Lights Operational Test
_____________________________________
A. General
(1) This procedure contains an operational test of the upper and lower anticollision lights.
B. Reference
(1) AMM 24-22-00/201, Manual Control
C. Access
(1) Location Zone
101 Control Cabin - Left
D. Procedure
S 865-001
(1)
Supply electrical power (AMM 24-22-00/201).
S 715-008
(2)
Put the ANTICOLLISION switch on the overhead panel, P5, in the ON position.
WARNING: DO NOT LET THE STROBE LIGHT FLASH DIRECTLY IN YOUR EYES.
_______ THE INTENSITY OF THE LIGHT CAN CAUSE YOU TO NOT SEE TEMPORARILY.
(a) Make sure the two anticollision lights flash.
S 715-009
(3)
Put the ANTICOLLISION switch on the overhead panel, P5, in the OFF position.
(a) Make sure the two anticollision lights go off.
(4)
Remove electrical power if it is not necessary (AMM 24-22-00/201).
S 865-007
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
33-44-00
ALL ú ú 02 Page 501 ú Jul 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
UPPER ANTICOLLISION LIGHT - REMOVAL/INSTALLATION
________________________________________________
1. General________
A. This procedure contains these tasks:
(1)
Upper Anticollision Light Removal
(2)
Upper Anticollision Light Installation
(3)
Upper Anticollision Light - Lens Removal
(4)
Upper Anticollision Light - Lens Installation
B. The upper anticollision light is installed on the top of the fuselage, above the leading edge of the wing.
(1)
When you do the removal of the light procedure, you remove the light from the inner side of the airplane. The lens is not removed.
(2)
When you do the removal of the lens procedure, you remove the lens from outside the airplane. The light is not removed.
TASK 33-44-13-004-001
2. Upper Anticollision Light Removal (Fig. 401)_________________________________
A. References
(1)
AMM 25-21-45/401, Sculptured Ceiling Panels
(2)
SSM 33-40-02
(3)
WDM 33-44-01
B. Access
(1) Location Zone
100 Upper Half of Fuselage
C. Light Removal
S 864-002
(1) Do one of these steps to remove electrical power from the upper anticollision light:
(a)
At the overhead panel, P5, set the switch to the off position and attach the DO-NOT-OPERATE tag.
(b)
Open each applicable circuit breaker and attach the DO-NOT-CLOSE tag: 1) On the load control center panel, P18.
S 014-004
(2) Get access to the upper anticollision light.
(a)
Lower or remove the right ceiling panel under the light. (Ref 25-21-45/401).
(b)
ON SOME AIRPLANES; Push inboard on the folded part of the air conditioning duct.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
33-44-13
ALL ú ú 01 Page 401 ú Jul 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
UPPER ANTICOLLISION LIGHT
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 燈 LIGHTS(81)
