S 035-012
(2)
Remove the lens of the inboard landing and runway turnoff lights (AMM 33-42-21/401).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
33-42-41
ALL ú ú 01 Page 506 ú Mar 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
(3) S 865-016Make sure the airplane and the test area are on level ground.
(4) S 865-032Make sure the airplane is approximately level (AMM 08-10-00/201).
(5) S 945-010Set the target in its position (Fig. 503).
NOTE:____ The target must be sufficiently large to see when you adjust the light. For the target, you can make a mark on the ground or set an object on the ground.
(6) S 865-030Supply electrical power (AMM 24-22-00/201).
(7) S 825-007Adjust the light.
CAUTION:_______ DO NOT MAKE THE LIGHTS COME ON FOR MORE THAN FIVE MINUTES. AFTER YOU MAKE THE LIGHTS COME ON, MAKE THE LIGHTS GO OFF FOR AN EQUAL TIME. BECAUSE OF THE HEAT, THE CONTINUED OPERATION OF THE LIGHTS CAN DECREASE THE LIFE OF THE LAMPS.
(a) At the overhead panel, P5, set the switch for the runway turnoff light to the on position.
WARNING:_______ DO NOT TOUCH THE HOT LAMP WITH YOUR BARE HANDS. LAMP CAN BURN YOUR SKIN. A HOT
(b) (c) Turn the adjustment screws of the runway turnoff light until the center of the light beam is on the mark.Set the switch to the off position.
(8) S 945-006Remove the target.
(9) S 435-005Install the lens for the inboard landing and runway turnoff lights (AMM 33-42-21/401).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
33-42-41
ALL ú ú 01 Page 507 ú Mar 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
GHT BEAM LI 56 FEET
TARGET
LOCATION OF THE MARK FOR THE RIGHT RUNWAY TURNOFF LIGHT
(LEFT LIGHT IS SYMMETRICAL)
A TARGET IS A MARK OR AN OBJECT THAT IDENTIFIES A LOCATION ON THE GROUND
Runway Turnoff Lights (Adjustment with a Target) Figure 503
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
33-42-41
ALL ú ú 01 Page 508 ú Jul 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
S 865-007
WARNING:_______ YOU MUST CAREFULLY DO THE STEPS IN THE TASK BELOW TO REMOVE THE
LEADING EDGE FLAP AND SLAT LOCKS CORRECTLY. THE LEADING EDGE
FLAPS AND SLATS CAN MOVE QUICKLY IF YOU DO NOT REMOVE THE LOCKS
CORRECTLY. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO
EQUIPMENT.
(10)
Do this task: "Leading Edge Flap and Slat Locks Removal" (AMM 27-81-00/201).
S 865-012
(11)
Remove the electrical power if it is not necessary (AMM 24-22-00/201).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
33-42-41
ALL ú ú 01 Page 509 ú Mar 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
NOSE GEAR TAXI LIGHT - MAINTENANCE PRACTICES
____________________________________________
1. General
_______
A. This procedure contains the task for the replacement of the lamp in the nose gear taxi light (referred to as the light).
B. The nose gear taxi light is installed on a support bracket with vibration isolators.
TASK 33-42-51-962-013
2. Nose Gear Taxi Light Lamp Replacement (Fig. 201)
_____________________________________
A. References
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 燈 LIGHTS(71)
