Control Wheel Control Sensor Cables
Figure 402

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. BEJ 101-999 ú

 31-24-32
 ú ú 05 Page 407 ú Jul 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 CONTROL WHEEL POSITION SENSOR - ADJUSTMENT/TEST
_______________________________________________
 1.  General_______
 A.  This procedure has one task. This task is the test of the control wheel position transmitter with the use of the portable tester or the autopilot test set.
 TASK 31-24-32-705-001
 2.  Control Wheel Position Transmitter Adjustment Test with the Portable Tester____________________________________________________________________________
 A.  Special Tools and Equipment
 (1)  
One of these portable testers which can select SUBFRAMES and WORDS to show the data for the flight data recorder. The Teledyne tester 2222786 or the AlliedSignal 981-6301-002 can be used when testing on airplanes installed with flight data recorder (FDR) that records up to 64 wps. Use the Teledyne tester 2229738-1 on airplanes installed with FDR that records up to 128 wps. Use the Teledyne tester 2229738-1 Mod E on airplanes installed with 256 wps FDR.

 (a)  
Flight Line Tester, Teledyne P/N 2222786, 2229738-1 or 2229738-1 Mod E Teledyne Controls, 12333 W. Olympic Blvd., West Los Angeles, CA 90064

 (b)  
Digital Signal Display unit, AlliedSignal P/N 981-6301-002, AlliedSignal, PO Box 7002 4747 Harrison Ave. Rockford, IL 61101

 (2)
Adapter Cable - Tester, Flight Data Recorder System P/N A31007

 NOTE: The tester cable consists of a cable assembly that is
____ approximately 60 inches long with a connector and a dust cap on each end. Use the -2 cable of the -1 kit when using the Teledyne tester 2222786. Use the -32 cable of -30 kit (on airplanes with FDEP) or -35 cable of the -49 kit (on airplanes without FDEP) when using the AlliedSignal tester 981-6301-002. Use the -60 cable of the -59 kit when using the the Teledyne tester 2229738-X.
 B.  References
 (1)  
24-22-00/201, Manual Control

 (2)  
27-11-00/201, Aileron and Aileron Trim Control System

 (3)  
29-15-00/201, Hydraulic Systems A, B and Standby

 C.  Access
 (1)  Location Zone
 202 Lower Nose Compartment

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. B-2535 AND ON ú

 31-24-32
 ú ú 09 Page 501 ú Jul 12/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 (2)  Access Panel
 1103 Forward Access Door

 D. Prepare for Test
 S 865-002
 (1)  
Supply electrical power (Ref 24-22-00/201).

 S 015-003

 (2)  
Remove the shorting plug from the system test plug on the P18 panel.

 S 485-004

 (3)  
Use the adapter cable to connect the portable tester to the system test plug.

 S 865-007

 (4)  
Set the portable tester switches as follows:

 SWITCH______ POSITION POWER ON WORD as given in the test SUBFRAME as given in the test INPUT ARINC INPUT DATA DATA PARAMETER SYNC B OCTAL DISPLAY SWITCH 12 BIT
 S 865-009
 WARNING: MAKE SURE PERSONS AND EQUIPMENT ARE CLEAR OF ALL CONTROL
_______ SURFACES BEFORE YOU SUPPLY HYDRAULIC POWER. AILERONS, RUDDERS, ELEVATORS, FLAPS, SPOILERS, LANDING GEAR, AND THRUST REVERSERS CAN MOVE QUICKLY WHEN YOU SUPPLY HYDRAULIC POWER. THIS CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 (5) Supply pressure to hydraulic systems A and B (Ref 29-15-00/201).
 E. Sensor Test
 S 865-010
 (1)  
Make sure the flight data recorder TEST--NORMAL switch is in the TEST position.

 (2)  
Make sure the control wheel is in the neutral position.

 S 865-011
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. B-2535 AND ON ú
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機(jī)維護(hù)手冊 儀表 INSTRUMENTS(97)