曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

____ in the lower nose compartment or you can use a locally made test cable. The cable is put up through the control stand and lets you use the ohmmeter in the control cabin.
 1)  Make sure there is no continuity through the switch.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 31-26-21
 ALL  ú ú 02 Page 405 ú Mar 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 (e) (f)  Move the applicable thrust lever forward until the switch operates (continuity through the switch C and NO terminals). 1) Make sure the thrust lever is 32+/-1 degree forward of the idle position.If the switch does not operate at the correct position, adjust the position of the switch bracket.
 NOTE:____ On some airplanes there is an adjustment screw on the switch. This screw permits you to adjust these switches without movement of the switch bracket.
 (g)  Move the applicable thrust lever full forward. 1) Make sure the switch stays in operation (there is continuity through the switch terminals).
 (4)  S 714-014Do these tasks if you adjusted the position of the switch bracket: "Control Stand Wing Anti-Ice Switches" (Ref 30-11-51/401) and "Thrust Reverser Arm and Stow Switches" (Ref 78-34-05/201).
 (5)  S 084-015Remove the ohmmeter.
 (6)  S 864-016Connect the electrical wires to the switch.
 (7)  S 864-018Remove the DO-NOT-CLOSE tags and close these circuit breakers: (a) P6 Load Control Center - Right 1) LANDING GEAR LIGHTS 2) ANTI-SKID FAIL WARN AND PARK BRAKE 3) AURAL WARN
 (8)  S 714-017Do this task:  "Takeoff Warning System Test" (Ref 31-26-00/501).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 31-26-21
 ALL  ú ú 02 Page 406 ú Mar 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 FLAP TAKEOFF WARNING SWITCH - REMOVAL/INSTALLATION
__________________________________________________
 1.  General_______
 A.  This procedure has two tasks. The tasks include a removal and an installation of the flap takeoff warning switch (S130). The installation task also has an adjustment procedure.
 B.  The flap warning switch and the flap limit switches are on the flap control unit in the right wheel well (Fig. 401).
 C.  The flap-up limit switch is part of the flap control system. This switch supplies an input to the warning system as an auxiliary function. The removal/installation for this switch is included in Chapter 27, Flight Controls.
 TASK 31-26-23-024-001
 2.  Flap Takeoff Warning Switch Removal___________________________________
 A.  Equipment and Materials
 (1)  
Gear Ground Lockpin - F72735

 (2)  
Flap Drum Checknut Wrench - 65-22958-1
 or F80197-1 or -5 Wrench Set

 

 B.  Access
 (1)  Location Zone
 217 Right Main Wheel Well

 C.  Procedure
 S 214-002
 (1)  
Make sure you installed all the ground lockpins for the landing gear.

 S 864-003

 (2)  
Open these circuit breakers and attach DO-NOT-CLOSE tags:

 (a)  P6 Load Control Center - Right
 1) AURAL WARN
 2) LIGHTS
 3) GEAR SWITCH & ANTI-SKID TEST

 (3)  
Remove the switch cover from the flap control unit.

 S 014-004
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 31-26-23
 ALL  ú ú 02 Page 401 ú Nov 15/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
SEE A
SEE B
FLAP CONTROL UNIT
SWITCH COVER
FLAP UP LIMIT SWITCH
INBD
A-A
NO. 4 FLAP DRIVE
SWITCH
COVER

A A
FLAP TAKEOFF WARNING SWITCH (S130) SEE A-A
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 儀表 INSTRUMENTS(157)