曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 1.  General
_______
 A.  The engine instrument system (EIS) primary display unit has a feature to monitor the engines for exceedance and abnormal start conditions. Any engine exceedance or any N1, N2 or EGT, beyond the red-line limit, will be stored in non-volatile RAM. This data is recorded at one-second intervals and also includes the fuel flow rate and the air/ground condition at the time of the recording.
 B.  This procedure provides the steps for the retrieval and erasure of engine exceedance data from the EIS primary display unit. This procedure can be performed only when the airplane is on the ground and the engines are not running.
 C.  This subject has two procedures, primary and optional. In the primary procedure, the interface between the ARINC reader and the EIS test connector is provided by the EIS Data Retrieval Test Box. In the optional procedure, you will have to provide the interface between the ARINC reader and the EIS test connector.
 TASK 31-42-00-802-004
 2.  Retrieve and Erase Engine Exceedance Data with the Data Bus Analyzer
____________________________________________________________________
 A.  Equipment
 (1)  
C31003-1 EIS Data Retrieval Test Box

 (2)  
ARINC 429 Data Bus Analyzer - J.C. Air Model 429EBP or equivalent

 B.  References
 (1) 24-22-00/201, Maintenance Practices (Apply Electrical Power)
 C.  Prepare To Retrive/Erase Engine Exceedances
 S 862-001
 (1)  
Make sure these EIS circuit breakers are closed:

 (a)  P6-2 Load Control Center - Right
 1) EIS PRIMARY 1
 2) EIS PRIMARY 2
 3) EIS PRIMARY 3
 4) EIS PRIMARY 4

 (2)
Supply electrical power, if it is necessary (AMM 24-22-00/201).

 (3)
Remove the protective cover from the EIS test connector (D10146).

 S 862-002
 S 032-003
 NOTE: The EIS test connector (D10146) is located on a stanchion of
____
 E2 rack, in the E/E compartment.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH EIS ú

 31-42-00
 ú ú 01 Page 201 ú Jul 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 862-033
 (4)
Connect the data retrieval test box to the EIS test connector.

 S 482-005

 (5)
Connect the ARINC 429 bus reader to the data retrieval test box.

 D. Retrieve Engine Exceedances
 S 972-022
 (1) Push the INTERROGATE switch on the EIS Data Retrieval Test Box.
 NOTE: Approximately 20 seconds after the INTERROGATE discrete is
____ applied, the data is available at the ARINC reader. The output format of all exceedance/abnormal start condition data is given in Table A.
 E. Erase Engine Exceedances
 S 072-021
 CAUTION: YOU MUST RETRIEVE THE EXCEEDANCE DATA FIRST BEFORE YOU CLEAR
_______
 THE EXCEEDANCE DATA.

 (1) Push the ERASE switch on the EIS Data Retrieval Test Box.
 NOTE: This will reset the exceedance memory in the EIS Primary
____
 Display to zero.

 F. Put The Airplane To Its Usual Condition
 S 012-034
 (1)
Remove the ARINC 429 bus reader from the data retrieval test box.

 S 082-009

 (2)
Remove the EIS Data Retrieval Test Box from the EIS test connector.

 S 432-010

 (3)
Install the protective cover on the EIS test connector (D10146).

 (4)
Remove electrical power, if it is not necessary (AMM 24-22-00/201).

 S 862-008
 TASK 31-42-00-802-014
 3. Retrieve and Erase Engine Exceedance Data with the Data Bus Analyzer
____________________________________________________________________
 (Optional)

__________
 A. Equipment
 (1) ARINC 429 Data Bus Analyzer - J.C. Air Model 429EBP or equivalent
 B. References
 (1) 24-22-00/201, Maintenance Practices (Apply Electrical Power)
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH EIS ú

 31-42-00
 ú ú 01 Page 202 ú Jul 15/98
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 儀表 INSTRUMENTS(178)