- ADIRU-3 (1FP3)

 - wiring of the ADIRU 3 BUS 2 IR from the ISIS indicator (22FN) to the ADIRU 3 (1FP3)

 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 34-12-34-000-001 Removal of the ADIRU (1FP1, 1FP2, 1FP3)
 AMM 34-12-34-400-001 Installation of the ADIRU (1FP1, 1FP2, 1FP3)
 AMM 34-14-00-740-001 Interface Test of the IR
 AMM 34-22-25-000-001 Removal of the ISIS Indicator (22FN)
 AMM 34-22-25-400-001 Installation of the ISIS Indicator (22FN)
 ASM 34-22/02

 3. Fault Confirmation
__________________
 A. Test
 Not applicable, you cannot confirm this fault on the ground.

 4. Fault Isolation
_______________
 A. If the fault symptom is identified by the maintenance message on the face of the ISIS indicator: ADIRU3(1FP3) BUS IR/ISIS(22FN-10FC)
 - do the interface test of the IR (system 3) (Ref. AMM TASK 34-14-00-740-001).
 (1) If the test gives a maintenance message, do the trouble shooting procedure related to the maintenance message.

 (2) If the test is OK:

 - do a check of the wiring of the ADIRU 3 BUS 2 IR from the ISIS indicator (22FN) to the ADIRU 3 (1FP3) (Ref. ASM 34-22/02).
 (a) If there is no continuity:
 - replace the defective wiring.
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 106-149, 213-213, 221-299, 301-399, ∞∞34-22-00∞∞∞∞∞∞∞∞∞∞Page 217
 401-499, Aug 01/05 CES (b) If there is continuity:

 - replace the IND-ISIS (22FN) (Ref. AMM TASK 34-22-25-000-001) (Ref. AMM TASK 34-22-25-400-001).
 1_ After the subsequent flight, if the fault continues:
 - replace the ADIRU-3 (1FP3) (Ref. AMM TASK 34-12-34-000-001)
 (Ref. AMM TASK 34-12-34-400-001).

 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 106-149, 213-213, 221-299, 301-399, ∞∞34-22-00∞∞∞∞∞∞∞∞∞∞Page 218
 401-499, Aug 01/05 CES

 Failure of the Mode Pin-Programming Discrete of the ISIS Indicator
 1. Possible Causes
_______________
 - IND-ISIS (22FN)

 - aircraft wiring

 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 34-22-25-000-001 Removal of the ISIS Indicator (22FN) AMM 34-22-25-400-001 Installation of the ISIS Indicator (22FN) ASM 34-22/02
 3. Fault Confirmation
__________________
 A. Test
 Not applicable, you cannot confirm this fault on the ground.

 4. Fault Isolation
_______________
 A. If the fault symptom is identified by the maintenance message on the face of the ISIS indicator: WRG:MODE DISCRETE/ISIS(22FN-10FC) and by the white flag on the face of the ISIS indicator: MAINT
 - remove the IND-ISIS (22FN) (Ref. AMM TASK 34-22-25-000-001)

 - do a check of pins A/X, h, a on the rack connector

 - make sure that there is an open circuit between pins A/X, h, a.

 (1) If the pin programming is incorrect:

 - repair the aircraft wiring (Ref. ASM 34-22/02)

 - install the IND-ISIS (22FN) (Ref. AMM TASK 34-22-25-400-001).

 (2) If the pin programming is correct:

 - replace the IND-ISIS (22FN) (Ref. AMM TASK 34-22-25-000-001) (Ref. AMM TASK 34-22-25-400-001).
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 106-149, 213-213, 221-299, 301-399, ∞∞34-22-00∞∞∞∞∞∞∞∞∞∞Page 219
 401-499, Aug 01/05 CES

 Failure of the Pin-Programming Parity of the ISIS Indicator
 1. Possible Causes
_______________
 - IND-ISIS (22FN)

 - aircraft wiring

 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
　
中國(guó)航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊(cè) 導(dǎo)航 NAVIGATION 2(98)