B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-50-00-400-002 Installation of the Inboard and Outboard Flap
Hoisting-Sling
27-50-00-400-003 Installation of the Lock-Torque Shaft - Flaps and
Slats (98D27504030001)
27-50-00-866-008 Extension of the Flaps on the Ground
27-54-49-000-001 Removal of the Flap Track 1 Actuator 6205CM(6255CM)
27-54-49-000-002 Removal of the Flap Track 2 Actuator 6211CM(6261CM)
27-60-00-866-002 Extension-Retraction of the Spoilers for Maintenance
32-12-00-010-001 Open the Main Gear Doors for Access
53-35-11-000-001 Removal of the Wing-to-Fuselage Fairings
57-51-33-000-001 Removal of the No.1 Flap Track Beam
57-51-37-000-002 Removal of the Access Panels 573AB(673AB),
573BB(673BB), 573CB(673CB)
57-55-11-000-001 Removal of the Flap Track Fairings Nos. 2, 3 and 4
57-55-11-000-004 Removal of the Flap Track Fairings Nos. 2, 3 and 4
**ON A/C 001-049, 051-061, 101-103, 201-203,
R 27-54-55-991-001 Fig. 401 **ON A/C 062-099, 104-105, 151-158, 204-210,
R 27-54-55-991-001-A Fig. 401A **ON A/C 106-149, 159-199, 211-299, 401-499,
R R 27-54-55-991-001-C **ON A/C 301-399, Fig. 401B
R R 27-54-55-991-001-B Fig. 401C **ON A/C 001-049, 051-099, 101-105, 151-199, 201-212,
27-54-55-991-004 Fig. 402
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
R **ON A/C 106-149, 213-299, 401-499,
R R 27-54-55-991-004-B **ON A/C 301-399, Fig. 402A
R 27-54-55-991-004-A **ON A/C ALL Fig. 402B
3. Job Set-up__________ Subtask 27-54-55-941-067
A. Safety Precautions
(1)
Put the safety barriers in position.
(2)
Put a warning notice(s) in the cockpit to tell persons not to operate the flight controls.
(3)
Put a warning notice in position to tell persons not to operate the landing gear doors.
Subtask 27-54-55-860-053
B. Aircraft Maintenance Configuration WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE
_______ CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE.
(1)
Extend the flaps fully (Ref. TASK 27-50-00-866-008).
(2)
Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER is installed on the flap/slat control lever.
(3)
For the track 2 lever assembly, fully extend the No. 1 Spoiler (Ref. TASK 27-60-00-866-002).
(4)
Make sure that the COLLAR-SAFETY, SPOILER COLLAR-SAFETY, SPOILER is on the poiston rod of the servo-control.
Subtask 27-54-55-865-050
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
Subtask 27-54-55-010-050
D. Get Access
(1)
Put the access platform in position below the applicable zone 573 or
673.
(2)
If necessary, remove the applicable access panels (Ref. TASK 53-35-11-000-001):
-
for the LH flap-actuator lever assembly, remove 193AB, 193BB
-
for the RH flap-actuator lever assembly, remove 194AB, 194BB.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FLIGHT CONTROLS 飛行操縱5(164)
