曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

52-40 26) Remove firewall-mounted inspection doors 212L (partial removal) and 212R (if installed), visually inspect for
cracks and security. 200  
52-40 27) Remove and visually inspect inspection doors 235L, 235R. 200  
53-00 28) Remove junction fairings 217R and 217L, visually inspect for cracks and security. 200  
53-00 29) Remove cowlings under hull 218A and 218F, visually inspect for cracks and security. 200  
53-00 Post-MOD. 151 200 NOTE 1 
 30) Remove and visually inspect fairings of retractable
footsteps 2111L and 2111R.   
52-40 All 200  
 31) Remove and check condition of inspection door 214 (if installed).   
52-40 32) Remove and check condition of baggage compartment bottom door 242. 200  
53-00 33) Remove and visually inspect tail cone 222 for cracks and security. Check condition of tail cone electrical wiring (if installed) - refer to 53-20-00 201. 200  
52-40 34) Remove and check condition of inspection doors 511, 512, 516 and (if installed) 515 - refer to 52-40-00 201. 500  
52-40 35) Remove and check condition of inspection doors 611, 612, 616 and (if installed) 615 - refer to 52-40-00 201. 600  

NOTE 1 : If a 100-hr. inspection has been carried out during the last 3 months, do not perform this operation unless this annual inspection replaces a 100-hr. inspection. For US registered aircraft, perform all operations.
ADAA
Validity : S / N 1 - 9999 05-20-06Page 203
(EA) JUN 01
 

ATA ANNUAL INSPECTION (Al)
COCKPIT AND FUSELAGE INSPECTION (AREA 200) AREA OTHER INSPECTION
PERFORMED
BY
53-00 COCKPIT AND FUSELAGE INSPECTION (AREA 200) 200  
53-00 1) Perform an overall visual inspection of area 200. 200  
11-00 2) Check installation and legibility of interior and exterior
placards and markings - refer to 11-20-00 1, 11-30-00 1. 200 NOTE 1 
25-10 3) Visually inspect attaching hardware, connections and markings on flight control instruments. 200  
77-00 4) Visually inspect the attach fittings, the connections and markings of the engine indicating instruments - refer to 31-10-03 201. 200  
31-20 5) Check the clock and the chronometer for correct operation (if installed). 200  
 Perform a calibration using an accurate external
instrument.   
25-10 6) Remove the covers forward of the instrument panel(s) and tilt the instrument panel(s). 200  
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：TB 20 MAINTENANCE MANUAL 05 TIME LIMITS MAINTENANCE CHECKS TB20飛機維護手冊 05 時間限制維護檢查 2(50)