曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

INSPECTION PERFORMED
BY
30-60 29) Visually inspect the supply lines of the propeller de-icing system (if installed) for routing, and condition of attach fittings - refer to 30-60-00 201. 000  
61-10 30) Install propeller spinner 111, make sure that washers are installed under the screw heads - refer to 61-10-00 401. 100  
61-10 31) Visually inspect the propeller governor. 100  
37-00 32) Replace the vacuum system filter (SIGMATEK pump, if installed). 100 500 hrs 
37-00 33) Replace the (mechanical) AIRBORNE vacuum pump drive (if installed). 100 Recommen  ded 6 years  
37-00 34) Visually inspect the vacuum system vacuum pump, the unions, fittings and pipes (if installed). Check the drive for oil leaks. 100  
74-10 35) Perform an overhaul of the TCM magneto. 100 Associated
with engine
overhaul or 
   4 years 
74-10 36) Check the TCM magneto, the attach fittings and the grounding. Refer to the latest issue of LYCOMING 100 100 hrs or
1 year 
 Service Bulletin No. 515 (SB 643 Teledyne Continental, Paragraphs 1 and 2B).   
74-10 37) Check the TCM magneto, the attach fittings and the grounding. Refer to the latest issue of LYCOMING 100 500 hrs 
 Service Bulletin No. 515 (SB 643 Teledyne Continental, Paragraphs 2A and 3).   
74-10 38) Check breaker points for pitting and minimum gap. 100  
74-10 39) Check for excessive oil in the breaker compartment ; if found, wipe dry with a clean lint-free cloth. 100  
74-10 40) The felt located at the breaker points should be lubricated in accordance with the magneto manufacturer's
instructions. 100  
74-10 41) Check magneto to engine timing. 100  
74-20 42) Remove and thoroughly inspect the upper and lower spark plugs. If the spark plugs are fouled, clean and adjust gap, then permute upper and lower spark plugs -refer to 74-20-02 201. 100  
74-20 43) Check the conductors and the ceramics for corrosion and deposits. 100  
 Clean the cable ends, spark plug walls and ceramics with a dry clean cloth or a clean cloth moistened with methyl-ethyl-ketone. Dry.   

AIAA
Validity : S / N 1 - 9999 05-20-04 (JA) Page 214
JUN 01
 

ATA "4A" INSPECTION - 100 HOURS
ENGINE COMPARTMENT INSPECTION (AREA 100) AREA OTHER INSPECTION
PERFORMED
BY
74-20 44) Check ignition harness clamps for security and spark plug and magneto terminals for tight connection. 100  
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：TB 20 MAINTENANCE MANUAL 05 TIME LIMITS MAINTENANCE CHECKS TB20飛機維護手冊 05 時間限制維護檢查 2(15)