AIAA
Validity : S / N 1 - 9999 05 20 05 Page 231
JUN 01
 

ATA "80A" MAJOR INSPECTION
STABILIZER INSPECTION (AREA 300) AREA OTHER
INSPECTION PERFORMED
BY
24-00 14) Visually inspect all cable connections in the vertical stabilizer. 300  
 Replace cables if damaged. Inspect cables for routing, clamp security, lugs and cleanliness.   
27-00 15) Check control surfaces for travel, efficiency and direction of flight controls : 000  
 - pitch - refer to 27-30-00 201,
- elevator trim tab - refer to 27-30-03 501, - rudder - refer to 27-20-00 201,
- rudder trim tab - refer to 27-20-04 201, - roll - refer to 27-10-00 201,
- wing flaps - refer to 27-50-00 501.   
20-00 16) Reinforce the anticorrosion protection - refer to 300  
 20-00-04 201 and lubricate - refer to 12-21-03 201.   

AIAA
Validity : S / N 1 - 9999 05-20-05 ,,A) Page 232
JUN 01
 

ATA "80A" MAJOR INSPECTION
FINAL STEPS AREA OTHER
INSPECTION PERFORMED
BY
 FINAL STEPS 000  
53-00 Post-MOD. 151 200  
 1) Install vertical stabilizer root front fairing 225.   
52-40 All 200  
 2) Install baggage compartment bottom door 242.   
52-40 3) Install landing gear hydraulic generator access door 238L. 200  
25-10 4) Install the sound-proofing panels and the cabin
upholstery panels. 200  
25-10 5) Tilt the instrument panel(s) back into position and install the covers forward of the instrument panel(s). 200  
52-40 6) Install inspection doors 235L, 235R. 200  
25-10 7) Install floor carpets and mats. 200  
25-10 8) Install the rear bench. 200  
25-10 9) Install the front seats and perform an operational test. 200  
 Check locking in all positions.   
24-40 10) Disconnect the external power supply source (if
installed). 200  
24-30 11) Connect the battery, lubricate the terminals - refer
to 24-30-02 201. 000  
52-40 12) Install battery access door 243 (battery at the rear). 200  
 Check that it is correctly locked.   
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：TB 20 MAINTENANCE MANUAL 05 TIME LIMITS MAINTENANCE CHECKS TB20飛機維護手冊 05 時間限制維護檢查 2(46)