52-31-02
 ALL  ú ú 02 Page 407 ú Feb 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 434-021
 (4)  
Install drive shaft coupling on the linear actuator with bolts, washers, and nuts.

 S 834-022

 (5)  
Remove rig pins ND-2.

 H.
Linear Actuator Test

 S 864-020
 (1)
Remove the DO-NOT-CLOSE tags and close these circuit breakers

 (a)  
On the Auxilary External 2 Power Center-Right panel P715: 1) 715XX, NOSE CARGO DOOR

 (b)  
On the Power Distribution Center-Right panel P415: 1) 415F16, NOSE CARGO DOOR CONTROL

 (c)  
On the Nose Cargo Door Power panel H122:
 1) 122XX, DOOR LIFT
 2) 122XX, PULL UP CAM
 3) 122XX, LATCHES 1-4R
 4) 122XX, LATCHES 1-4L
 5) 122XX, LATCHES 5-8R
 6) 122XX, LATCHES 5-8L

 S 864-021
 (2)  
Hold the door control switch in the CLOSE position until the door latch pins are fully engaged and LATCHES CLOSED light comes on.

 S 214-022

 (3)
Make sure the aft end of linear actuator shaft makes an overlap

 0.25 to 0.75 inch on the inspection hole (Detail B, Fig. 402).
 S 214-023
 (4)  
Make sure the forward position of actuator shaft touches the nylon support.

 S 714-024

 (5)  
Fully open the nose cargo door and make sure the actuators operate correctly.

 (6)  
Close, latch and lock the nose cargo door.

 (7)  
Make sure all nose cargo door lights are extinguished.

 S 864-025
 S 214-026
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 52-31-02
 ALL  ú ú 02 Page 408 ú Feb 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 I.  Put the Airplane Back To Its Usual Condition S 864-027
 (1) Remove electrical power, if it is not necessary.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 52-31-02
 ALL  ú ú 02 Page 409 ú Feb 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 NOSE CARGO DOOR LIFT MECHANISM MANUAL DRIVE - ADJUSTMENT/TEST
_____________________________________________________________
 1. General
_______
 A. This procedure contains these tasks:
 (1)  An operational test of the nose cargo door lift mechanism manual drive.
 TASK 52-31-02-705-001
 2. Nose Cargo Door Lift Mechanism Manual Drive - Functional Test
_____________________________________________________________
 A. General
 (1)  
You must adjust the lift mechanism using the steps in this procedure after you use the manual drive.

 (2)  
This is a scheduled maintenance task.

 B.
Equipment

 (1)  
MIT65B80430 - Alternate Drive Extension, Nose Cargo Door Lift Actuator (two quantities)

 (2)  
3/8-inch drive speed handles for manual operation of MIT65B80430 (two required)

 (3)  
Commercial air or electric reversible motors - 3000 rpm, no load maximum and 35 pound-inches minimum torque for power operation of MIT65B80430 (two required)

 (4)  
Adapter - 0.250-Inch Hex to 0.375-Inch Square Tang - Drive motors to MIT65B80430 connection

 (5)  
2MIT65B80430 Dual Outlet Rectifier Box

 NOTE: This tool used to rectify 400-Hz airplane electrical power to
____ dc utility power as an alternate means of supplying power to electric motors when used to drive MIT65B80430.
 (6)  
Rig Pin ND-2 - 0.311-inch diameter, 2 inches long (two required)

 (7)  
PRE65B13015 Safety Barrier - Nose Cargo Door

 C.
References

 (1)  
AMM 52-31-00/501, Nose Cargo Door

 D.
Access

 (1)  
Location Zone
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 艙門 DOORS 2(36)