Nose Cargo Door Installation
Figure 401 (Sheet 2)
B26878
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
52-31-01
ALL ú ú 02 Page 403 ú Jun 10/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
FORWARD SPREADER BEAM OVERHEAD CRANE 20HME65B13015 SLING ASSEMBLY
LIFT CABLE (4 LOCATIONS)
DOOR NOSE CARGO
HINGE ACCESS DOOR (2 LOCATIONS)
FORWARD LIFT LIFT BRACKET BRACKET
(2 LOCATIONS)
A
DOOR
AFT LIFT
BRACKET
(2 LOCATIONS)
A
FWD
SEEA B
PORTAL LATCH FITTING
(21 LOCATIONS)
SLING INSTALLATION
INNER OUTER NUT/WASHER NUT/WASHER
LOOSE STUD PAD
INBD
A-A
Nose Cargo Door Installation
Figure 402 (Sheet 1)
B26869
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
52-31-01
ALL ú ú 02 Page 404 ú Feb 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
DOOR REMOVAL/INSTALLATION
(DOOR SHOWN IN THE 15-DEGREE OPEN POSITION)
Nose Cargo Door Installation
Figure 402 (Sheet 2)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
52-31-01
ALL ú ú 02 Page 405 ú Feb 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
B26873
A
747-400
MAINTENANCE MANUAL
TO KEEP THE CABLES IN |5`
Nose Cargo Door Installation Figure 402 (Sheet 3)
B26874
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
52-31-01
ALL ú ú 02 Page 406 ú Feb 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 747-400 MAINTENANCE MANUAL
(b) (c) (d) (e) Install two loose stud pads on door with supplied bolts. 1) Make sure to install the inner nut and washer down to the stud as far as possible.Install lift bracket (with third pad) over two stud pads. 1) Put the bolts through the third pad and in the door.Install the outer nut and washer on two studs.Tighten the inner and outer nuts against the lift bracket.
S 864-061
(2) Use airplane power or the alternate drive extension to open the nose cargo door to the fully open position (73 degrees).
S 034-005
(3) Disconnect the hinge access door control rod. (a) Disconnect the control rod from the body structure. (b) Keep the hinge access door open with tape.
S 024-062
(4) Remove the nuts, washers, and cotter pins from the hinge bolts.
S 424-063
(5) Reinstall the large nuts. (a) Torque the large nuts to 30 - 35 pound-inches to make sure that the bolts will stay in place.
S 864-044
(6) Use the airplane power or the alternate drive extension to lower the nose cargo door to 15-degree open position (32 degrees from vertical).
S 494-056
(7) Install a wooden strut between the door and body to keep the door in this position.
S 864-045
(8) Open these circuit breakers and attach the DO-NOT-CLOSE tags: (a) On the Auxilary External 2 Power Center-Right panel P715: 1) NOSE CARGO DOOR (b) On the Power Distribution Center-Right panel P415: 1) 415F16, NOSE CARGO DOOR CONTROL (c) On the Nose Cargo Door Power panel H122: 1) DOOR LIFT
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
52-31-01
ALL ú ú 02 Page 407 ú Jun 10/97
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 艙門 DOORS 2(29)
