34-11-00
ALL ú ú 02 Page 548 ú Feb 10/93
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
S 865-067
CAUTION:_______ MAKE SURE THAT THE PITOT LINE PRESSURE IS EQUIVALENT OR MORE
THAN THE STATIC LINE PRESSURE. KEEP THE STATIC PRESSURE
CHANGES LESS THAN 5000 FEET FOR EACH MINUTE. MAKE SURE THAT
THE DIFFERENTIAL PRESSURE STAYS BETWEEN 0 AND 10.19 INCHES OF
MERCURY. YOU CAN CAUSE DAMAGE TO THE PITOT-STATIC SYSTEM.
(5)
Open the static cutoff valve.
S 865-296
(6)
Put the captain's static system to ambient pressure.
S 085-068
CAUTION: DO NOT DISCONNECT THE PNEUMATIC TEST SET WHEN THE PITOT-STATIC
_______ SYSTEM IS NOT AT AMBIENT PRESSURE. YOU CAN CAUSE DAMAGE TO THE EQUIPMENT.
(7) Disconnect the pneumatic test set from the test fitting.
S 085-497
WARNING: FAILURE TO REMOVE THE VINYL ADHESIVE TAPE FROM THE STATIC
_______ PORTS BEFORE FLIGHT MAY CAUSE LARGE ERRORS IN AIRSPEED SENSING AND ALTITUDE SENSING SIGNALS, WHICH MAY LEAD TO LOSS OF SAFE FLIGHT.
CAUTION: MAKE SURE THAT YOU REMOVE ALL OF THE PIECES OF TAPE FROM EACH
_______ PITOT-STATIC PROBE. THE SYSTEM WILL NOT OPERATE CORRECTLY WHEN THE TAPE IS IN ITS POSITION.
(8) Remove the vinyl adhesive tape from these locations:
(a)
The forward static ports (S1) in the upper left pitot-static probe.
(b)
The aft static ports (S2) in the lower right pitot-static probe.
S 215-070
(9)
Examine the static ports for unwanted materials and rough locations on the inner and outer surfaces (Ref 34-11-01/601).
S 865-071
(10)
Close these circuit breakers and remove the DO-NOT-CLOSE tags:
(a) P6 Main Power Distribution Panel 1) 6D30 PROBE HEAT PITOT L 2) 6D33 PROBE HEAT AUX PITOT R 3) 6E01 PRIM T/E FLAP CONT AC
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
34-11-00
ALL ú ú 01 Page 549 ú Feb 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
4) 6E02 PRIM T/E FLAP CONT DC
TASK 34-11-00-795-072
15. The First Officer's Static System Leak Test (Low-Range)
_______________________________________________________
A. Standard Tools and Equipment
(1)
Pneumatic Test Set
(a) Vacuum source, 10 to 30 inches of mercury (absolute)
(2)
Gages
(a) Static system test gage - required to indicate 10 to 30 inches of mercury (absolute) with accuracy of |0.1 (readable to |0.01) inch of mercury or |200 (readable to |20) feet.
(3)
Flow restrictors, control valves, cutoff valves, and pressure tape as required.
B. References
(1) 34-11-01/601, Pitot-Static Probe
C. Access
(1) Location Zone 115 Area Between Nose Gear Well and Fuselage, LH 116 Area Between Nose Gear Well and Fuselage, RH 118 Electrical and Electronics Compartment, RH
D. Procedure
S 865-297
WARNING: MAKE SURE THAT YOU DO NOT APPLY ELECTRICAL POWER TO THE FLIGHT
_______ CONTROLS. FLIGHT CONTROL SURFACES CAN MOVE AUTOMATICALLY WHEN YOU PRESSURIZE THE PITOT-STATIC SYSTEM. THIS CAN CAUSE INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT.
CAUTION: MAKE SURE THAT YOU DO NOT APPLY ELECTRICAL POWER TO THE
_______ PITOT-STATIC PROBE HEATERS. YOU CAN CAUSE DAMAGE TO THE PITOT-STATIC PROBES.
(1) Open these circuit breakers and attach DO-NOT-CLOSE tags:
(a) P6 Main Power Distribution Panel
1) 6D31 PROBE HEAT PITOT R
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
34-11-00
ALL ú ú 02 Page 550 ú Oct 10/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
2) 6D32 PROBE HEAT AUX PITOT L
3) 6E01 PRIM T/E FLAP CONT AC
4) 6E02 PRIM T/E FLAP CONT DC
S 485-498 中國航空網 m.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：747-400 AMM 飛機維護手冊 導航 NAVIGATION 1(57)
