曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

____ pointer to the nearest aft corner of the groove in the rudder index plate.
 2)  Measure and make a record of the distance between the trailing edges of the upper rudder and the lower rudder (this is the mismatch).
 NOTE: The mismatch is positive if the upper rudder is
____ outboard of the lower rudder. The mismatch is negative if the upper rudder is inboard of the lower rudder.
 3) Calculate the travel of the upper rudder: LT = Lower rudder travel (in inches) UT = Upper rudder travel (in inches) MM = mismatch between the lower and upper rudder (in
 inches)
 UT = LT + (1.24 X MM)
 4)  Make sure the travel of the lower rudder and the upper rudder is 13.4-15.9 inches.
 (f)  
Release the rudder pedals.

 (g)  
If procedure 1 was used to extend the actuator, push the LSK that is adjacent to END TEST> on the CDU.

 (h)  
If procedure 2 was used to extend the actuator, slowly remove the pressure from the pitot-static system (AMM 34-11-00/201).

 N.  
Put the Airplane Back to Its Usual Condition

 (1)
Remove rig pin E-1 from the captain's control column (Fig. 501).

 S 095-091
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-21-00
 ALL  ú ú 02 Page 542 ú Jun 18/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 095-092
 WARNING:_______ MAKE SURE THE NOSE LANDING GEAR IS POINTED FORWARD.  IF THE
 TIRES ARE NOT PARALLEL WITH THE AIRPLANE, THEY CAN TURN QUICKLY
 WHEN YOU REMOVE THE TOW PIN.  THIS CAN CAUSE INJURY TO PERSONS

 AND DAMAGE TO EQUIPMENT.
 (2)  
Remove the TOW PIN at the nose landing gear (AMM 09-11-00/201).

 S 865-094

 (3)  
Find the switches for the FLT CONTROL HYD POWER on the Pilot's Overhead Maintenance Panel, P461.

 (a)  
Put the four TAIL switches in the NORM position.

 S 865-096
 (4)  
Remove hydraulic power (AMM 29-11-00/201).

 S 865-097

 (5)  
Remove electrical power if it is not necessary (AMM 24-22-00/201).

 S 415-098

 (6)  
Install all access doors and access panels (AMM 06-09-05/201, AMM 06-09-07/201).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-21-00
 ALL  ú ú 01 Page 543 ú Jun 18/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 UPPER AND LOWER RUDDER - REMOVAL/INSTALLATION
_____________________________________________
 1.  General_______
 A.  This procedure has five tasks. The first two remove and install the lower rudder. The second two remove and install the upper rudder. The fifth task is to do an operational test of the rudders.
 B.  You must remove the lower rudder before you can remove the upper rudder.
 C.  The procedure to remove the lower rudder has these basic steps:
 (1)  
Put the upper rudder in the full right position.

 (2)  
Make sure the airplane is in a safe condition.

 (3)  
Install support equipment for the rudder.

 (4)  
Disconnect the hinges and the power control package (PCP) from the rudder.

 (5)  
Remove the rudder.

 D.  
The procedure to install the lower rudder has these basic steps:

 (1)  
Make sure the seals are in good condition.

 (2)  
Put the rudder in its position.

 (3)  
Connect the hinges and the PCP's for the rudder.

 (4)  
Remove the support equipment.

 E.  
The procedure to remove the upper rudder has these basic steps:

 (1)  
Remove the lower rudder.

 (2)  
Install support equipment for the upper rudder.

 (3)  
Disconnect the hinges and the power control package (PCP) from the rudder.

 (4)  
Remove the rudder.

 F.  
The procedure to install the upper rudder has these basic steps:
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 2(64)